Show simple item record

dc.contributor.authorRobert Tremblay
dc.contributor.authorAli Davaran
dc.date.accessioned2022-01-30T20:05:25Z
dc.date.available2022-01-30T20:05:25Z
dc.date.issued2020
dc.identifier.other%28ASCE%29ST.1943-541X.0002455.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4266497
dc.description.abstractA method based on elastic stability analysis to design bolted single shear lap (SSL) connections, which are traditionally used for hollow structural section (HSS) bracing members, is proposed in this paper. The method includes connections with different lap plate thicknesses. An approximate nonlinear analysis method is also presented to mimic the inelastic buckling and post-buckling response of the connections. These approaches are validated by the existing experimental results of three X-bracing specimens and by the numerical results obtained from nonlinear finite element (FE) analysis. The results show that the design procedure proposed by the current guidelines for the HSS can be improved using the calculated effective length factor of this study. Lastly, a stiffened SSL connection detail is suggested for X-bracings and is assessed through the employed analytical methods. This detail is efficiently able to prevent the formation of the three-hinge buckling mode in SSL connections by omitting one of the involved plastic hinges. By using this detail, the compression strength of the connections is enhanced to a level that is normally demanded by special concentric braced frames (SCBF).
dc.publisherASCE
dc.titleDesign of Bolted Single Shear Lap Connection with Different Thicknesses of Splice Plates
dc.typeJournal Paper
dc.journal.volume146
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002455
dc.page04020004
dc.treeJournal of Structural Engineering:;2020:;Volume ( 146 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record