Show simple item record

dc.contributor.authorAfrin Hossain
dc.contributor.authorMarjan Popovski
dc.contributor.authorThomas Tannert
dc.date.accessioned2019-09-18T10:38:00Z
dc.date.available2019-09-18T10:38:00Z
dc.date.issued2019
dc.identifier.other%28ASCE%29ST.1943-541X.0002357.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4259611
dc.description.abstractCross-laminated timber (CLT) panels, when used as shear walls or diaphragms, are commonly connected with multiple (n) dowel-type fasteners in a row. For such connections, it is frequently observed that the load-carrying capacity of multiple fasteners is less than the sum of the individual fastener capacities, a phenomenon referred to as the group effect. The research presented in this paper investigated the group effect in self-tapping screw (STS) shear connections between CLT panels. Different joint types (surface splines with STS in shear, and half-lap and butt joints with STS in either shear or withdrawal) were evaluated in a total of 175 quasi-static monotonic and reversed cyclic tests, with the number of STS in one row varied between 2 and 32. The results showed that the group effect for the joint capacity (strength) can be expressed as neff=0.9n for all joints under static loading, where neff is the effective number of fasteners. In case of cyclic loading, a more pronounced group effect was observed that can be expressed as neff=n0.9. These reductions are significantly less conservative than the current Canadian design provisions for lag screws. For the reduction in stiffness and ductility, neff=n0.8 and neff=n0.9 can be used for all joints under static and cyclic loading, respectively. Finally, the capacity, ductility, and stiffness for joints under cyclic loading where the STS acted in withdrawal were on average 10% lower compared with the static values.
dc.publisherAmerican Society of Civil Engineers
dc.titleGroup Effects for Shear Connections with Self-Tapping Screws in CLT
dc.typeJournal Paper
dc.journal.volume145
dc.journal.issue8
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0002357
dc.page04019068
dc.treeJournal of Structural Engineering:;2019:;Volume ( 145 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record