• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Blade Element Momentum Study of Rotor Aerodynamic Performance and Loading for Active and Passive Microjet Systems

    Thumbnail
    View/Open
    jert_141_05_051213.pdf (1.375Mb)
    Date
    2019
    Author
    Hurley, Owen F.
    Chow, Raymond
    Blaylock, Myra L.
    Cooperman, Aubryn M.
    van Dam, C. P.
    Metadata
    Show full item record
    Abstract
    This study investigates the performance of microjets for load reduction on the NREL-5 MW wind turbine and identifies optimal system parameters. Microjets provide blowing normal to the blade surface and can rapidly increase or decrease lift on a blade section, enabling a wind turbine to respond to local, short-term changes in wind condition. As wind turbine rotors become larger, control methods that act on a single blade or blade section are increasingly necessary to reduce critical fatigue and extreme loads. However, microjets require power to operate, and thus, it is crucial that the fatigue reduction justifies any energy input to the system. To examine the potential for fatigue reduction of a range of potential microjet system configurations, a blade element momentum (BEM) code and a flow energy solver were used to estimate the energy input and the change in primary fatigue metrics. A parametric analysis was conducted to identify the optimal spanwise position and length of the microjets over a range of air mass flow rates. Both active and passive air supply methods were considered. A passive microjet system applied to the NREL 5-MW rotor produced a 3.7% reduction in the maximum flapwise root bending moment (FRBM). The reduction in the peak bending moment increased to 6.0% with a 5 kPa blower that consumes approximately 0.1% of the turbine output power. The most effective configurations placed microjets between the blade midspan to three-quarters span. Load reduction was achieved for both active and passive modes of air supply to the microjet system.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4259114
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV