Show simple item record

dc.contributor.authorCao, Tong
dc.contributor.authorYu, Kaian
dc.contributor.authorChen, Xuyue
dc.contributor.authorGao, Deli
dc.contributor.authorZhu, Hongwu
dc.contributor.authorLuo, YunQing
dc.date.accessioned2019-09-18T09:06:55Z
dc.date.available2019-09-18T09:06:55Z
dc.date.copyright4/4/2019 12:00:00 AM
dc.date.issued2019
dc.identifier.issn0195-0738
dc.identifier.otherjert_141_9_093101
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4259025
dc.description.abstractRecently, a new type of jet mill bit (JMB) has been introduced to improve the cutting transport efficiency in horizontal drilling by comminuting cuttings into dust-like particles immediately after the cuttings are generated. To promote the application of JMBs in the field, in this work, JMBs were further improved by including junk slots (JS) all around to allow cuttings to flow through the annulus and thereby prevent sticking from occurring while tripping out. Moreover, numerical and experimental investigations on the feasibility of horizontal drilling with the new type of JMB were carried out. The finite element method was used to analyze the strength of the new type of JMB, and flow field simulation analysis was also performed for JMBs with different sizes of JS. The simulation results indicated that the weakest point of the JMB was located at the bit connection instead of the bit frame, and it was demonstrated that the structural strength of the JMB met the requirements of actual working conditions. The JMB JS had a negative effect on promoting the upward return of cuttings from the bottom of the hole, and the larger the slot sizes were, the more negative the effects. Through a trip-out experiment with the new type of JMB, this paper studied the influence of the slot size on the trip-out process safety. The experimental results indicated that the minimum safe slot width was 60 mm. Finally, in a synthesis of the simulation and experimental results, the reasonable range of slot width was determined to be 60–70 mm; the aforementioned range was the most suitable for the bit based on safety and efficiency considerations. This paper provides guidance for the improvement and application of JMBs.
dc.publisherAmerican Society of Mechanical Engineers (ASME)
dc.titleNumerical and Experimental Investigation on the Feasibility of Horizontal Drilling With a New Type of Jet Mill Bit
dc.typeJournal Paper
dc.journal.volume141
dc.journal.issue9
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4043246
dc.journal.fristpage93101
dc.journal.lastpage093101-9
dc.treeJournal of Energy Resources Technology:;2019:;volume 141:;issue 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record