Show simple item record

dc.contributor.authorVishwas Nandkishor Khatri; Jyant Kumar
dc.date.accessioned2019-03-10T12:08:01Z
dc.date.available2019-03-10T12:08:01Z
dc.date.issued2019
dc.identifier.other%28ASCE%29GM.1943-5622.0001370.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4254948
dc.description.abstractThe lower- and upper-bound theorems of the limit analysis have been used in conjunction with finite elements and second-order cone programming (SOCP) for determining the bearing capacity of strip and circular skirted footings on sand. The analysis follows the Mohr-Coulomb’s yield criterion and the associated flow rule; sand is not usually considered to obey this rule, but the results of using it are discussed. The friction angle of sand was varied between 30 and 45°, and the depth (Ds) of the skirt increased from 0.25 to 2B; here B implies: (1) the width of a skirted strip footing, and (2) the diameter of a circular skirted footing. The results are expressed in terms of the bearing capacity ratio (BCR): the ratio of the bearing capacities of a skirted footing to that of the surface footing, with the same value of B but without any skirt element. The results reveal that the magnitude of the BCR increases quite extensively with an increase in the value of Ds/B. The skirted footing was found to be especially quite advantageous for loose sand. With the same Ds/B, the BCR for a circular skirted footing was found to be substantially greater than that for the strip skirted footing.
dc.publisherAmerican Society of Civil Engineers
dc.titleFinite-Element Limit Analysis of Strip and Circular Skirted Footings on Sand
dc.typeJournal Paper
dc.journal.volume19
dc.journal.issue3
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0001370
dc.page06019001
dc.treeInternational Journal of Geomechanics:;2019:;Volume ( 019 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record