Show simple item record

dc.contributor.authorBassiony, Mohamed A.
dc.contributor.authorSadiq, Abdellatif M.
dc.contributor.authorGergawy, Mohammed T.
dc.contributor.authorAhmed, Samer F.
dc.contributor.authorGhani, Saud A.
dc.date.accessioned2019-02-28T11:14:35Z
dc.date.available2019-02-28T11:14:35Z
dc.date.copyright10/12/2018 12:00:00 AM
dc.date.issued2018
dc.identifier.issn0195-0738
dc.identifier.otherjert_140_12_122202.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4254210
dc.description.abstractNew induction manifold designs have been developed in this work to enhance the turbulence intensity and improve the mixing quality inside diesel engine cylinders. These new designs employ a spiral-helical shape with three different helical diameters (1D, 2D, 3D; where D is the inner diameter of the manifold) and three port outlet angles: 0 deg, 30 deg, and 60 deg. The new manifolds have been manufactured using three-dimensional printing technique. Computational fluid dynamics simulations have been conducted to estimate the turbulent kinetic energy (TKE) and the induction swirl generated by these new designs. The combustion characteristics that include the maximum pressure raise rate (dP/dθ) and the peak pressure inside the cylinder have been measured for a direct injection (DI) diesel engine utilizing these new manifold designs. In addition, engine performance and emissions have also been evaluated and compared with those of the normal manifold of the engine. It was found that the new manifolds with 1D helical diameter produce a high TKE and a reasonably strong induction swirl, while the ones with 2D and 3D generate lower TKEs and higher induction swirls than those of 1D. Therefore, dP/dθ and peak pressure were the highest with manifolds 1D, in particular manifold m (D, 30). Moreover, this manifold has provided the lowest fuel consumption with the engine load by about 28% reduction in comparison with the normal manifold. For engine emissions, m (D, 30) manifold has generated the lowest CO, SO2, and smoke emissions compared with the normal and other new manifolds as well, while the NO emission was the highest with this manifold.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInvestigating the Effect of Utilizing New Induction Manifold Designs on the Combustion Characteristics and Emissions of a Direct Injection Diesel Engine
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue12
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4041543
dc.journal.fristpage122202
dc.journal.lastpage122202-15
dc.treeJournal of Energy Resources Technology:;2018:;volume 140:;issue 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record