Show simple item record

dc.contributor.authorAbo-Elfadl, Saleh
dc.contributor.authorAbd El-Sabor Mohamed, A.
dc.date.accessioned2019-02-28T11:14:28Z
dc.date.available2019-02-28T11:14:28Z
dc.date.copyright10/4/2017 12:00:00 AM
dc.date.issued2018
dc.identifier.issn0195-0738
dc.identifier.otherjert_140_03_032203.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4254191
dc.description.abstractInlet port design has a great influence on swirl generation inside the engine cylinder. In this paper, two helical inlet ports having the same helix design were suggested. The first has an upper entrance, and the second has a side entrance. With the two ports, shrouded inlet valves having different conditions of shroud and orientation angles were used. Four shroud angles were used; they are 90 deg, 120 deg, 150 deg, and 180 deg. Also, four orientation angles were used; they are 0 deg, 30 deg, 60 deg, and 90 deg. Three-dimensional simulation model using the shear stress transport k–ω model was used for predicting the air flow characteristics through the inlet port and the engine cylinder in both intake and compression strokes. The results showed that the side entrance port produces swirl ratio higher than that of the upper entrance port by about 3.5%, while the volumetric efficiency is approximately the same for both ports. For both the ports, increasing the valve shroud angle increases the swirl ratio and reduces the volumetric efficiency. The maximum increments of swirl ratio relative to the ordinary valve case occur at valve conditions of 30–150 deg, 0–180 deg, and 30–180 deg. At these valve conditions, the swirl ratio values are 6.38, 6.72, and 6.95 at intake valve close (IVC) with percentage increments of 69.2%, 78.2%, and 84.4%, respectively. The corresponding values of the volumetric efficiency are 93.6, 92.5, and 91.2, respectively, with percentage decrements of 2.84%, 4%, and 5.7%, respectively.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of the Helical Inlet Port Design and the Shrouded Inlet Valve Condition on Swirl Generation in Diesel Engine
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4037941
dc.journal.fristpage32203
dc.journal.lastpage032203-9
dc.treeJournal of Energy Resources Technology:;2018:;volume 140:;issue 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record