• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Proportional–Integral Controller Design for Combustion-Timing Feedback, From n-Heptane to Iso-Octane in Compression–Ignition Engines

    Thumbnail
    View/Open
    ds_140_05_054502.pdf (2.069Mb)
    Date
    2018
    Author
    Ingesson, Gabriel
    Yin, Lianhao
    Johansson, Rolf
    Tunestål, Per
    Metadata
    Show full item record
    Abstract
    The problem of designing robust and noise-insensitive proportional–integral (PI) controllers for pressure-sensor-based combustion-timing control was studied through simulation. Different primary reference fuels (PRF) and operating conditions were studied. The simulations were done using a physics-based, control-oriented model with an empirical ignition-delay correlation. It was found that the controllable region in between the zero-gain region for early injection timings and the misfire region for late injection timings is strongly PRF dependent. As a result, it was necessary to adjust intake temperature to compensate for the difference in fuel reactivity prior to the controller design. With adjusted intake temperature, PRF-dependent negative-temperature coefficient (NTC) behavior gave different system characteristics for the different fuels. The PI controller design was accomplished by solving the optimization problem of maximizing disturbance rejection and tracking performance subject to constraints on robustness and measurement-noise sensitivity. Optimal controller gains were found to be limited by the high system gain at late combustion timings and high-load conditions; furthermore, the measurement-noise sensitivity was found to be higher at the low-load operating points where the ignition delay is more sensitive to variations in load and intake conditions. The controller-gain restrictions were found to vary for the different PRFs; the optimal gains for higher PRFs were lower due to a higher system gain, whereas the measurement-noise sensitivity was found to be higher for lower PRFs.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4253938
    Collections
    • Journal of Dynamic Systems, Measurement, and Control

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV