• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Nested Plant/Controller Codesign Using G-Optimal Design and Continuous Time Adaptation Laws: Theoretical Framework and Application to an Airborne Wind Energy System

    Thumbnail
    View/Open
    ds_140_12_121013.pdf (1.889Mb)
    Date
    2018
    Author
    Deese, Joe
    Vermillion, Chris
    Metadata
    Show full item record
    Abstract
    This paper presents a nested codesign (combined plant and controller design) formulation that uses optimal design of experiments (DoE) techniques at the upper level to globally explore the plant design space, with continuous-time control parameter adaptation laws used at the lower level. The global design space exploration made possible through optimal DoE techniques makes the proposed methodology appealing for complex, nonconvex optimization problems for which legacy approaches are not effective. Furthermore, the use of continuous-time adaptation laws for control parameter optimization allows for the extension of the proposed optimization framework to the experimental realm, where control parameters can be optimized during experiments. At each full iteration, optimal DoE are used to generate a batch of plant designs within a prescribed design space. Each plant design is tested in either a simulation or experiment, during which an adaptation law is used for control parameter optimization. Two techniques are proposed for control parameter optimization at each iteration: extremum seeking (ES) and continuous-time DoE. The design space is reduced at the end of each full iteration, based on a response surface characterization and quality of fit estimate. The effectiveness of the approach is demonstrated for an airborne wind energy (AWE) system, where the plant parameters are the center of mass location and stabilizer area, and the control parameter is the trim pitch angle.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4253909
    Collections
    • Journal of Dynamic Systems, Measurement, and Control

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV