• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Modeling of Heat Transfer in an Aluminum X-Ray Anode Employing a Chemical Vapor Deposited Diamond Heat Spreader

    Thumbnail
    View/Open
    ht_140_12_124501.pdf (2.387Mb)
    Date
    2018
    Author
    Stupple, David J.
    Kemp, Victor
    Oldfield, Matthew J.
    Watts, John F.
    Baker, Mark A.
    Metadata
    Show full item record
    Abstract
    X-ray sources are used for both scientific instrumentation and inspection applications. In X-ray photoelectron spectroscopy (XPS), aluminum Kα X-rays are generated through electron beam irradiation of a copper-based X-ray anode incorporating a thin surface layer of aluminum. The maximum power operation of the X-ray anode is limited by the relatively low melting point of the aluminum. Hence, optimization of the materials and design of the X-ray anode to transfer heat away from the aluminum thin film is key to maximizing performance. Finite element analysis (FEA) has been employed to model the heat transfer of a water-cooled copper-based X-ray anode with and without the use of a chemical vapor deposited (CVD) diamond heat spreader. The modeling approach was to construct a representative baseline model, and then to vary different parameters systematically, solving for a steady-state thermal condition, and observing the effect on the maximum temperature attained. The model indicates that a CVD diamond heat spreader (with isotropic thermal properties) brazed into the copper body reduces the maximum temperature in the 4 μm aluminum layer from 613 °C to 301 °C. Introducing realistic anisotropy and inhomogeneity in the thermal conductivity (TC) of the CVD diamond has no significant effect on heat transfer if the aluminum film is on the CVD diamond growth face (with the highest TC). However, if the aluminum layer is on the CVD diamond nucleation face (with the lowest TC), the maximum temperature is 575 °C. Implications for anode design are discussed.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4251848
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV