Show simple item record

dc.contributor.authorDavletbaev, A.
dc.contributor.authorKovaleva, L.
dc.contributor.authorZainulin, A.
dc.contributor.authorBabadagli, T.
dc.date.accessioned2019-02-28T11:00:37Z
dc.date.available2019-02-28T11:00:37Z
dc.date.copyright3/9/2018 12:00:00 AM
dc.date.issued2018
dc.identifier.issn0022-1481
dc.identifier.otherht_140_06_062001.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4251688
dc.description.abstractProduction of heavy oil from deep/tight formation using traditional technologies (“cold” production, injection of hot steam, etc.) is ineffective or inapplicable. An alternative is electromagnetic (EM) heating after fracturing. This paper presents the results of a numerical study of heavy oil production from a well with hydraulic fracture under radiofrequency (RF) EM radiation. Two parameters ignored in our previous modeling studies, namely adiabatic effect and the thermal expansion of oil, are considered in the new formulation, while high gradients of pressure/temperature and high temperature occur around the well. The mathematical model calculates the distribution of pressure and temperature in the system of “well-fracture-formation.” The distribution of thermal heat source is given by the Abernetty expression. The mathematical model takes into account the adiabatic effect and the thermal expansion of heavy oil. The latter makes a significant contribution to heavy oil production. Multistage heavy production technology with heating is assumed and several stages are recognized: stage 1: “Cold” heavy oil production, stage 2: RF-EM heating, and stage 3: RF is turned off and “hot” oil production continues until the flow rate reaches its initial (before heating) value. These stages are repeated starting from the second stage. Finally, RF-EM heating technology is compared to “cold” production in terms of additional oil production and economics. When producing with RF-EM heating with power 60 kW (50 days in the second stages), the oil rate increased several times. Repeated RF-EM heating (25 days in the fourth stage) doubled the production rate. Near-well region temperature increased by ∼82 °C in the second stage with RF-EM heating. Temperature increased by ∼87 °C in the fourth stage with repeated RF-EM heating and production cycles. Economic analysis and evaluation of energy balance showed that the multistage production technology is more efficient; i.e., the lower the payback period, the greater the energy balance. With the increase in pressure difference, the payback period and energy balance increased linearly.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Modeling of Heavy-Oil Recovery Using Electromagnetic Radiation/Hydraulic Fracturing Considering Thermal Expansion Effect
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue6
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4038853
dc.journal.fristpage62001
dc.journal.lastpage062001-11
dc.treeJournal of Heat Transfer:;2018:;volume( 140 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record