• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    On Convective Heat Transfer and Flow Dynamics Through a Straight T-Bifurcating Channel

    Thumbnail
    View/Open
    ht_140_03_031701.pdf (2.311Mb)
    Date
    2018
    Author
    Abdelhak, Lakehal
    Nora, Nait-Bouda
    Julien, Pelle
    Souad, Harmand
    Metadata
    Show full item record
    Abstract
    Both experimental and numerical studies of a turbulent flow in a bifurcating channel are performed to characterize the dynamical behavior of the flow and its impact on the convective heat transfer on the sides of the branch. This configuration corresponds to the radial vents placed in the stator vertically to the rotor–stator air gap in the electrical machines. Indeed, our analysis focuses on the local convective heat transfer on the vents internal surface under a turbulent mass flow rate. The flow field measurements were carried out with two components particle image velocimetry (PIV) system, and the local heat transfer on the sides of the bifurcation branch was measured using an infrared thermography device. The convective heat transfer and the flow dynamics through the geometry are investigated numerically considering a three-dimensional (3D) flow. The closure system of the Navier–Stokes equations for steady and incompressible flow is based on the low-Reynolds numbers Reynolds stress model (RSM) (RSM-stress-ω). The comparison of the 3D computed results with the measurements in the xy symmetry plane is satisfactory in the vertical and horizontal channels. The numerical prediction of the secondary flow in the vertical branch was analyzed and complements the experimental results. It was particularly noticed that the accelerated flow observed at the right side of the branch's inlet allows more pronounced heat transfer comparatively to the left side. Beyond approximately 7 hydraulic diameters from the entrance of the branch, the Nusselt number curves on the two sides of the branch tend to be the same developed Nusselt number, Nud.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4251633
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV