| dc.description.abstract | Characterization of materials undergoing severe plastic deformation requires the careful measurement of instantaneous sample dimensions throughout testing. For compressive testing, it is insufficient to simply estimate sample diameter from an easily measured height and volume. Not all materials exhibit incompressibility, and friction during testing can lead to a barreled sample with diameter that varies with height. Video extensometry has the potential to greatly improve testing by capturing the full profile of a sample, allowing researchers to account for such effects. Common two-dimensional (2D) video extensometry algorithms require thin, planar samples, as they are unable to account for out-of-plane deformation. They are, therefore, inappropriate for standard compressive tests which use cylindrical samples that exhibit large degrees of out-of-plane deformation. In this paper, a new approach to 2D video extensometry is proposed. By using background subtraction, the profile of a cylindrical sample can be isolated and measured. Calibration experiments show that the proposed system has a 3.1% error on calculating true yield stress—similar to ASTM standard methods for compressive testing. The system is tested against Aluminum 2024-T351 in a series of cold upsetting tests. The results of these tests match very closely with similar tests from the literature. A preliminary finite element model constructed using data from these tests successfully reproduced experimental results. Diameter data from the finite element model undershot, but otherwise closely matched experimental data. | |
