• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    In-Cylinder Flow Evolution Using Tomographic Particle Imaging Velocimetry in an Internal Combustion Engine

    Thumbnail
    View/Open
    jert_140_01_012207.pdf (4.303Mb)
    Date
    2018
    Author
    Kumar Agarwal, Avinash
    Gadekar, Suresh
    Pratap Singh, Akhilendra
    Metadata
    Show full item record
    Abstract
    In-cylinder flows in internal combustion (IC) engines have always been a focus of study in order to gain better understanding of fuel–air mixing process and combustion optimization. Different conventional experimental techniques such as hot wire anemometry (HWA), laser Doppler anemometry (LDA), and numerical simulations have been grossly inadequate for complete understanding of the complex 3D flows inside the engine cylinder. In this experimental study, tomographic particle imaging velocimetry (PIV) was applied in a four-valve, single-cylinder optical research engine, with an objective of investigating the in-cylinder flow evolution during intake and compression strokes in an engine cycle. In-cylinder flow seeded with ultra-fine graphite particles was illuminated by a high energy, high frequency Nd:YLF laser. The motion of these tracer particles was captured using two cameras from different viewing angles. These two-directional projections of flowfield were used to reconstruct the 3D flowfield of the measurement volume (36 × 25 × 8 mm3), using multiplicative algebraic reconstruction technique (MART) algorithm. Captured images of 50 consecutive engine cycles were ensemble averaged to analyze the in-cylinder flow evolution. Results indicated that the in-cylinder flows are dependent on the piston position and spatial location inside the engine cylinder. The randomness of air-flow fields during the intake stroke was very high, which became more homogeneous during the compression stroke. The flows were found to be highly dependent on Z plane location inside the engine. During the intake stroke, flows were highly turbulent throughout the engine cylinder, and velocities vectors were observed in all directions. However, during the compression stroke, flow velocities were higher near the injector, and they reduced closer to the valves. Absolute velocity during compression stroke was mainly contributed by the out of plane velocity (Vz) component.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4250889
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV