Show simple item record

dc.contributor.authorLim Yi Xian;Tan Siew Ann;Phoon Kok-Kwang
dc.date.accessioned2019-02-26T07:42:45Z
dc.date.available2019-02-26T07:42:45Z
dc.date.issued2018
dc.identifier.other%28ASCE%29GM.1943-5622.0001186.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4248871
dc.description.abstractA simplified numerical procedure to model a deep-penetration process, press-replace method (PRM), was used to simulate a cone penetration test (CPT) in undrained conditions with finite-element software. A detailed description is given on how PRM can be implemented in CPT. The performance of PRM was validated by comparing results obtained with solutions from three other numerical approaches: large-deformation finite element (LDFE), steady-state finite element (SSFE), and material point method (MPM). For a wide range of soil rigidities, initial soil stress anisotropy and roughness conditions, normalized cone factors from PRM using a Tresca model, agreed within 1% of LDFE, and the average value was greater than LDFE by 4%. Total stress, principal stress directions, and magnitudes from PRM were also found to be similar to LDFE results. The PRM approach was then applied to a modified Cam-clay soil model. Excess pore-pressure distributions calculated around the cone agreed well with solutions by SSFE. For a smooth cone with various initial stress states, PRM calculated cone tip resistances that were approximately 7% more than MPM.
dc.publisherAmerican Society of Civil Engineers
dc.titleApplication of Press-Replace Method to Simulate Undrained Cone Penetration
dc.typeJournal Paper
dc.journal.volume18
dc.journal.issue7
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0001186
dc.page4018066
dc.treeInternational Journal of Geomechanics:;2018:;Volume ( 018 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record