Show simple item record

dc.contributor.authorFortes Ernesto S.;Parsekian Guilherme A.;Fonseca Fernando S.;Camacho Jefferson S.
dc.date.accessioned2019-02-26T07:41:38Z
dc.date.available2019-02-26T07:41:38Z
dc.date.issued2018
dc.identifier.other%28ASCE%29ST.1943-541X.0001978.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4248764
dc.description.abstractMasonry walls and columns are common structural members that typically resist compressive loads, with a number of such members being required to resist combined axial load and out-of-plane bending due to direct out-of-plane loads or an eccentricity of the axial compressive load. Flexural compression strength is usually greater than axial compression strength, and a reasonable experimental data set supports this assertion. However, little information exists for high-strength concrete block masonry subjected to combined axial and flexural loadings. This paper presents axial and flexural compression strengths and deformation properties of high-strength concrete block masonry. Seventy-two masonry prisms were constructed and tested to evaluate the capacity and behavior of high-strength structural masonry subject to compressive concentric and eccentric loading; both grouted and hollow prisms were used. Block strengths of 44, 56, and 67 MPa are considered. The results show an increase of flexural compression strength of 15–29% for the hollow prisms and of 7–79% for the grouted prisms compared with their axial compression strength. Measured ultimate strain varies from .14 to .19% for the axial compression and from .2 to .25% for the flexural compression. Hollow prism strength varies from 52 to 62% of the block strength, whereas grouted prism strength varies from 43 to 59% of the block strength.
dc.publisherAmerican Society of Civil Engineers
dc.titleHigh-Strength Concrete Masonry Walls under Concentric and Eccentric Loadings
dc.typeJournal Paper
dc.journal.volume144
dc.journal.issue6
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0001978
dc.page4018055
dc.treeJournal of Structural Engineering:;2018:;Volume ( 144 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record