• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Ultimate Strain Criteria for RC Members in Monotonic or Cyclic Flexure

    Thumbnail
    View/Open
    %28ASCE%29ST.1943-541X.0001501.pdf (3.607Mb)
    Date
    2016
    Author
    Sofia Grammatikou
    Dionysis Biskinis
    Michael N. Fardis
    Metadata
    Show full item record
    Abstract
    A large number of experimental curvatures in plastic hinges of concrete members are used alongside analytical moment-curvature relations to backestimate strains in the bars, the extreme concrete fibers of a section, or its confined core at the ultimate conditions of concrete sections in flexure with axial loads. Strain limits derived from these ultimate strains can support fiber models for prismatic members or models with finite-length plastic hinges at the ends. The measurements come from circular or rectangular columns (some tested diagonally), walls, or beams. The ultimate strains derived for steel bars and concrete are not local material properties (especially for cyclic loading): they depend on the geometric features of the section as a whole and of the immediate vicinity of the most critical point in the section. The size effects are clear: (1) concrete ultimate strains increase in a small compression zone, (2) the monotonic ultimate strain of tension bars increases with decreasing number of bars in the tension zone, (3) the ultimate strain of steel in cyclic tests increases with the increasing number of bars in the compression zone, and (4) the ultimate strain of confined concrete is larger at a section corner in biaxial bending than along the full side of a rectangular compression zone in uniaxial flexure, while at the perimeter of a circular section, it is in between these two extremes. The cyclic ultimate strain of steel in tension increases as the bar diameter–to–stirrup spacing ratio increases, thanks to the delay of bar buckling in previous compression half-cycles. The ultimate strains derived apply both as mean values in a plastic hinge and at the end section of prismatic members. Compared to experimental ultimate curvatures, those computed from the proposed ultimate strains do not have bias and exhibit much less scatter than those obtained from arbitrary ultimate strains specified in some codes. These code predictions are, in general, unsafe.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4244526
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV