Show simple item record

dc.contributor.authorCheng Yu
dc.contributor.authorMohamad Yousof
dc.contributor.authorMahsa Mahdavian
dc.contributor.authorWenying Zhang
dc.date.accessioned2017-12-30T13:00:55Z
dc.date.available2017-12-30T13:00:55Z
dc.date.issued2016
dc.identifier.other%28ASCE%29ST.1943-541X.0001493.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4244522
dc.description.abstractThin-walled cold-formed steel (CFS) clip angles are commonly used to connect CFS framing members or attach CFS members to the main building structure. The design provisions for CFS clip angle connectors have not been included in the AISI design specifications and standards. This paper presents a research project aimed at developing a design method for the thin-walled cold-formed steel load bearing clip angles subjected to shear forces. An extensive test program was conducted to investigate the behavior and shear capacity of clip angles with various dimensions and thicknesses. It was found that the local buckling and the distortional buckling could dominate the failure mechanism dependent on the plate slenderness ratio. Based on the test results, two design methods were developed for determining the nominal shear strength of load bearing clip angles with and without consideration of the clip deformation, respectively. The ASD safety factors and the LRFD resistance factor were also produced to support the proposed design provisions.
dc.publisherAmerican Society of Civil Engineers
dc.titleBehavior and Design of Thin-Walled Cold-Formed Steel Clip Angles Subjected to Shear Load
dc.typeJournal Paper
dc.journal.volume142
dc.journal.issue7
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0001493
dc.page04016040
dc.treeJournal of Structural Engineering:;2016:;Volume ( 142 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record