Show simple item record

dc.contributor.authorNa Chen
dc.contributor.authorXiaobo Zhang
dc.contributor.authorQinghui Jiang
dc.contributor.authorXixia Feng
dc.contributor.authorWei Wei
dc.contributor.authorBing Yi
dc.date.accessioned2017-12-30T12:58:30Z
dc.date.available2017-12-30T12:58:30Z
dc.date.issued2018
dc.identifier.other%28ASCE%29GM.1943-5622.0001048.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4244079
dc.description.abstractThe shear response of rock joints under bolt reinforcement is important for supporting the design of a jointed rock mass. This paper aims to investigate the shear behavior of bolted rock joints with different roughness. Direct shear tests on both bolted and unbolted artificial joint specimens were conducted under various normal stresses. Before shear tests, three kinds of roughnesses for joints were created by split tests, and the roughnesses were quantitatively evaluated by a three-dimensional morphology scanner. After shear tests, the results showed that the bolt deformation decreased with increasing normal stress and increased with increasing roughness. Furthermore, the shear stiffness of the bolted joint specimens was, without exception, greater than that of unbolted specimens. Compared with those of unbolted specimens, the peak shear strength and the residual shear strength of bolted joint specimens with different roughnesses were improved to different degrees. Using the Coulomb failure criterion to linearly fit the shear strength and the applied normal stress, the equivalent cohesion and friction angle of the bolted joint specimens were found to have evident improvements compared with those of unbolted joint specimens. The increment rate of the equivalent cohesion of the bolted specimens increased with increasing roughness, whereas that of the equivalent friction angle decreased with increasing roughness.
dc.publisherAmerican Society of Civil Engineers
dc.titleShear Behavior of Rough Rock Joints Reinforced by Bolts
dc.typeJournal Paper
dc.journal.volume18
dc.journal.issue1
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0001048
dc.page04017130
dc.treeInternational Journal of Geomechanics:;2018:;Volume ( 018 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record