• Login
    View Item 
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Vertical Facing Panel-Joint Gap Analysis for Steel-Reinforced Soil Walls

    Thumbnail
    View/Open
    %28ASCE%29GM.1943-5622.0000632.pdf (4.143Mb)
    Date
    2016
    Author
    I. P. Damians
    R. J. Bathurst
    A. Lloret
    A. Josa
    Metadata
    Show full item record
    Abstract
    This paper reports the results of a numerical parametric study focused on the prediction of vertical load distribution and vertical gap compression between precast concrete facing panel units in steel-reinforced soil walls ranging in height from 6 to 24 m. The vertical compression was accommodated by polymeric bearing pads placed at the horizontal joints between panels during construction. This paper demonstrates how gap compression and magnitude of vertical load transmitted between horizontal joints are influenced by joint location along the height of the wall, joint compressibility, and backfill and foundation soil stiffness. The summary plots in this study can be used to estimate the number and type (stiffness) of the bearing pads to ensure a target minimum gap thickness at the end of construction, to demonstrate the relative influence of wall height and different material component properties on vertical load levels and gap compression, or as a benchmark to test numerical models used for project-specific design. The paper also demonstrates that although the load factor (ratio of vertical load at a horizontal joint to weight of panels above the joint) and joint compression are relatively insensitive to foundation stiffness, the total settlement at the top of the wall facing is very sensitive to foundation stiffness. This paper examines the quantitative consequences of using a simple linear compressive stress–strain model for the bearing pads versus a multilinear model that is better able to capture the response of bearing pads taken to greater compression. The study demonstrates that qualitative trends in vertical load factor are preserved when a more advanced stress-dependent stiffness soil hardening model is used for the backfill soil as compared with the simpler linear elastic Mohr–Coulomb model. Although there were differences in vertical loads and gap compression with the use of both soil models for the backfill, the differences were small and not of practical concern.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4243358
    Collections
    • International Journal of Geomechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV