• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Engineering Mechanics
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Engineering Mechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Basic Mechanical Properties of Wet Granular Materials: A DEM Study

    Thumbnail
    View/Open
    %28ASCE%29EM.1943-7889.0001043.pdf (814.7Kb)
    Date
    2017
    Author
    Vinh Du Than
    Saeed Khamseh
    Anh Minh Tang
    Jean-Michel Pereira
    François Chevoir
    Jean-Noël Roux
    Metadata
    Show full item record
    Abstract
    Numerical simulations, by the discrete element method (DEM), of a model granular assembly, made of spherical balls, are used to investigate the influence of a small amount of an interstitial wetting liquid, forming capillary bridges between adjacent particles, on two basic aspects of granular material rheology: (1) the plastic response in isotropic compression, and (2) the critical state under monotonic shear strain, and its generalization to steady, inertial flow. Tensile strength F0=πΓa, in contacts between beads of diameter a joined by a small meniscus of a liquid with surface tension Γ, introduces a new force scale and a new dimensionless control parameter, P*=a2P/F0, for grains of diameter a under confining stress P. Under low P*, as cohesion dominates, capillary cohesion may stabilize very loose structures. Upon increasing pressure P in isotropic compression, such structures gradually collapse. The resulting irreversible compaction is well described by the classical linear relation between logP* and void ratio in some range, until a dense structure forms that retains its stability without cohesion as confinement dominates for large P*. In steady shear flow, with uniform velocity gradient γ˙=∂v1/∂x2 under normal stress P=σ22, the apparent internal friction coefficient, which is defined as μ*=σ12/σ22, depends on P* and inertial number (reduced shear rate) I=γ˙m/aP, and so does solid fraction Φ. The material exhibits, as P* decreases, a strongly enhanced resistance to shear (larger μ*). In the quasistatic limit, for I→0, it is roughly predicted by a simple effective pressure assumption by which the capillary forces are deemed equivalent to an isotropic pressure increase applied to the dry material as long as P*≥1, while the yield criterion approximately assumes the Mohr-Coulomb form. At lower P*, such models tend to break down as liquid bonding, causing connected clusters to survive over significant strain intervals, strongly influences the microstructure. Systematic shear banding is observed at very small P*.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4243066
    Collections
    • Journal of Engineering Mechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV