Show simple item record

dc.contributor.authorKigezi
dc.contributor.authorT. N.;Dunne
dc.contributor.authorJ. F.
dc.date.accessioned2017-12-30T11:44:06Z
dc.date.available2017-12-30T11:44:06Z
dc.date.copyright8/8/2017 12:00:00 AM
dc.date.issued2017
dc.identifier.issn0022-0434
dc.identifier.otherds_139_11_111010.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4242983
dc.description.abstractA general design approach is presented for model-based control of piston position in a free-piston engine (FPE). The proposed approach controls either “bottom-dead-center” (BDC) or “top-dead-center” (TDC) position. The key advantage of the approach is that it facilitates controller parameter selection, by the way of deriving parameter combinations that yield both stable BDC and stable TDC. Driving the piston motion toward a target compression ratio is, therefore, achieved with sound engineering insight, consequently allowing repeatable engine cycles for steady power output. The adopted control design approach is based on linear control-oriented models derived from exploitation of energy conservation principles in a two-stroke engine cycle. Two controllers are developed: A proportional integral (PI) controller with an associated stability condition expressed in terms of controller parameters, and a linear quadratic regulator (LQR) to demonstrate a framework for advanced control design where needed. A detailed analysis is undertaken on two FPE case studies differing only by rebound device type, reporting simulation results for both PI and LQR control. The applicability of the proposed methodology to other common FPE configurations is examined to demonstrate its generality.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Model-Based Control Design Approach for Linear Free-Piston Engines
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue11
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4036886
dc.journal.fristpage111010
dc.journal.lastpage111010-10
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2017:;volume( 139 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record