• Login
    View Item 
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Characterization of Joint Set Effect on Rock Pillars Using Synthetic Rock Mass Numerical Method

    Thumbnail
    View/Open
    %28ASCE%29GM.1943-5622.0000756.pdf (10.68Mb)
    Date
    2017
    Author
    Y. Zhang
    F. Ren
    X. Zhao
    Metadata
    Show full item record
    Abstract
    In this paper, a synthetic rock mass (SRM) method is used to numerically characterize the effect of joint sets on rock pillars. The SRM model is constructed by explicitly inserting discrete fracture network into a particle assembly. Conceptual SRM models show that pillar-loading capacity is weakened by inserted joints. Pillar peak strength is lower when inserted joints favor shear sliding of rock blocks, and strength becomes higher when pillar failure is controlled by fragmentation of intact rocks. Meanwhile, loading capacity is weakened when longer joints are simulated. The effect of joint sets on pillar modulus is similar to the observed effect on peak strength. Pillar failure behaves as a continuous shear failure when the inserted joints are inclined and changes into intact rock splitting when the joints become vertical. The SRM method is then used to characterize the joint set effect on real pillars in the Doe Run mine. A pillar model with a width/height ratio of 0.8 is initially constructed on the basis of derived joint characteristics from photogrammetric mapping. Numerical results show that the pillar peak strength and deformation modulus were reduced by 68.1 and 44.8%, respectively, in comparison with the corresponding properties of the joint-free model. A series of additional pillar SRM models is also studied, and SRM pillar strengths agree with the empirical formulas in general. Finally, this paper presents a comparison study between continuum and SRM models. The coincidence in findings between the two numerical methods further validates the robustness of the SRM method for characterizing joint set effect on rock pillars.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4240082
    Collections
    • International Journal of Geomechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV