Show simple item record

dc.contributor.authorZheng, Ce
dc.contributor.authorZhu, Mingming
dc.contributor.authorZhou, Wenxu
dc.contributor.authorZhang, Dongke
dc.date.accessioned2017-11-25T07:21:11Z
dc.date.available2017-11-25T07:21:11Z
dc.date.copyright2017/6/2
dc.date.issued2017
dc.identifier.issn0195-0738
dc.identifier.otherjert_139_03_032905.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4236937
dc.description.abstractThis paper reports the findings of an investigation into the molecular structures and properties of three asphaltene samples, namely, an asphaltene sample extracted from Buton Oil Sand (Indonesia), and two asphaltene samples extracted from vacuum residues from Liaohe Refinery (China) and Vene Refinery (Venezuela), respectively. The average molecular structural parameters, including the average polycyclic aromatic hydrocarbon (PAH) size, average side chain length, and average molecular weight (AMW), of the three asphaltene samples were estimated using data from nuclear magnetic resonance (NMR) in combination with distortionless enhancement by polarization transfer (DEPT), and then compared against each other. The molecular weight distributions (MWDs) of the three asphaltene samples were measured using a matrix-assisted laser desorption/ionization time-of-flight (MALDI-TOF) mass spectrometry. The results indicated that the island molecular architecture predominated in all three asphaltenes and the average polycyclic aromatic hydrocarbon size was found to be six rings. The average molecular weight of the Buton asphaltene sample was found to be ca. 800 Da while those of the two petroleum asphaltene samples were approximately 600 Da. In comparison, the Buton asphaltene sample contained a much higher level of oxygen and sulfur, but a lower aromaticity than those of the two petroleum asphaltene samples. The use of liquid NMR in combination with DEPT was shown to provide an effective method for characterization and estimation of the molecular structures of asphaltenes, supported by MALDI-TOF mass spectra.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Preliminary Investigation Into the Characterization of Asphaltenes Extracted From an Oil Sand and Two Vacuum Residues From Petroleum Refining Using Nuclear Magnetic Resonance, DEPT, and MALDI-TOF
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4035746
dc.journal.fristpage32905
dc.journal.lastpage032905-9
dc.treeJournal of Energy Resources Technology:;2017:;volume( 139 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record