Show simple item record

dc.contributor.authorAl-Gahtani, Husain J.
dc.contributor.authorNaffa'a, Mahmoud
dc.date.accessioned2017-11-25T07:19:02Z
dc.date.available2017-11-25T07:19:02Z
dc.date.copyright2016/29/9
dc.date.issued2017
dc.identifier.issn0094-9930
dc.identifier.otherpvt_139_02_021208.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4235546
dc.description.abstractPressure vessels that undergo repairs are normally pressure tested to verify their structural integrity before returning into service. Conventionally, the entire vessel is pressure tested, according to the relevant construction code. In this paper, partitioning the pressure vessel is suggested as an equivalent alternative test arrangement, where pressure testing is limited to the zone where a repair has been performed. Use of such an arrangement would alleviate potential concerns associated with the conventional testing method. Procedures are provided to specify the position of the partition relative to the repair location, in order to maintain the state-of-stress to that achieved in a conventional pressure test. Validity of this approach has been demonstrated for a repaired full-circumferential welded joint in the wall of a cylindrical pressure vessel.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleVerifying Structural Integrity of Repaired Cylindrical Pressure Vessels by Partitioning Method
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4034349
dc.journal.fristpage21208
dc.journal.lastpage021208-10
dc.treeJournal of Pressure Vessel Technology:;2017:;volume( 139 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record