Show simple item record

dc.contributor.authorJo, Byeongnam
dc.contributor.authorOkamoto, Koji
dc.date.accessioned2017-11-25T07:19:01Z
dc.date.available2017-11-25T07:19:01Z
dc.date.copyright2016/5/8
dc.date.issued2017
dc.identifier.issn0094-9930
dc.identifier.otherpvt_139_01_011406.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4235531
dc.description.abstractThis study aims to investigate the creep buckling behavior of a stainless steel column under axial compressive loading at extremely high temperatures. Creep buckling failure time of a slender column with a rectangular cross section was experimentally measured under three different temperature conditions, namely, 800, 900, and 1000 °C. At each temperature, axial compressive loads with magnitudes ranging between 15% and 80% of the buckling loads were applied to the top of the column, and the creep buckling failure time was measured to examine its relationship with the compressive load. The stainless steel column was found to fail within a relatively short time compared to that of creep deformation under tensile loading. An increase in the temperature of the column was found to accelerate creep buckling failure. The in-plane and out-of-plane column displacements, which respectively, corresponded to the axial and lateral displacements, were monitored during the entire experiment. The creep buckling behavior of the column was also visualized by a high-speed camera. Based on the Larson–Miller parameters (LMP) determined from the experimental results, an empirical correlation for predicting the creep buckling failure time was developed. Another empirical correlation for predicting the creep buckling failure time based on the lateral deflection rate was also derived.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Investigation Into Creep Buckling of a Stainless Steel Plate Column Under Axial Compression at Extremely High Temperatures
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4033155
dc.journal.fristpage11406
dc.journal.lastpage011406-8
dc.treeJournal of Pressure Vessel Technology:;2017:;volume( 139 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record