• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Intensification of Chemically Assisted Melt–Water Explosive Interactions

    Thumbnail
    View/Open
    ht_139_04_042004.pdf (2.569Mb)
    Date
    2017
    Author
    Sansone, Anthony A.
    Taleyarkhan, Rusi P.
    Metadata
    Show full item record
    Abstract
    This paper investigates avenues for controlled initiation and augmentation of the mechanical and thermal energetic output of shock-triggered vapor explosions (VEs) with Al–GaInSn alloys; furthermore, enabling a means for impulsive hydrogen gas generation within milliseconds. Using a submerged electronic bridgewire detonator or rifle primer caps as the shock trigger for VE initiation, experiments were conducted with 10 g melt drops at initial temperature between 930 K and 1100 K, aluminum mass contents between 0.3 wt.% and 20 wt.%, and water temperatures between 293 K and 313 K. It was found that combined thermal–chemical Al–GaInSn–H2O explosive interactions can readily be controllably induced via shocks and are of greater intensity than the pure (spontaneous) thermally driven explosions observed with unalloyed Sn and GaInSn. Shock pressures up to 5 MPa were recorded about 10 cm from the explosion zone; a factor of 5 higher than the ∼1 MPa over pressures generated from spontaneous GaInSn–H2O explosions reported in our previous study. Al–GaInSn–H2O explosive interactions also exhibited rapid enhancements to the “impulse” H2 production rate. Hydrogen/vapor bubble volumes up to 460 ml were observed approximately 4 ms after the explosion, equating to a mechanical work and instantaneous power output of 47 J and 11.75 kW, respectively. In comparison with available, analogous, triggered-explosion studies with Al melt drops, our Al–GaInSn alloy melt at 1073 K generated up to 18 times (∼2000%) more hydrogen per gram of aluminum when compared with experiments with molten Al at a much higher melt temperature of 1243 K.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4234398
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV