Show simple item record

dc.contributor.authorYu, X.
dc.contributor.authorWoodcock, C.
dc.contributor.authorWang, Y.
dc.contributor.authorPlawsky, J.
dc.contributor.authorPeles, Y.
dc.date.accessioned2017-11-25T07:17:02Z
dc.date.available2017-11-25T07:17:02Z
dc.date.copyright2017/21/6
dc.date.issued2017
dc.identifier.issn0022-1481
dc.identifier.otherht_139_11_112402.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4234367
dc.description.abstractAn experimental study on subcooled flow boiling with engineering fluid HFE-7000 in a microchannel fitted with piranha pin fins (PPFs) is presented. Heat fluxes of up to 735 W/cm2 were achieved and mass fluxes ranged from 618 kg/m2s to 2569 kg/m2 s. It was found that the flow boiling heat transfer was significantly enhanced with PPFs. The heat transfer coefficient with flow boiling was double the corresponding single-phase flow. Correlations for two-phase heat transfer coefficient and pressure drop in the nucleate flow boiling regime were developed based on the boiling, Weber, and Jakob numbers. The onset of nucleate boiling (ONB) and the critical heat flux (CHF) conditions were determined through visualization and was typically initiated from the last row of fins where temperatures were highest and flow rates lowest.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEnhanced Subcooled Flow Boiling Heat Transfer in Microchannel With Piranha Pin Fin
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue11
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4036683
dc.journal.fristpage112402
dc.journal.lastpage112402-13
dc.treeJournal of Heat Transfer:;2017:;volume( 139 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record