• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Dependence of Film Cooling Effectiveness on Three-Dimensional Printed Cooling Holes

    Thumbnail
    View/Open
    ht_139_10_102003.pdf (9.754Mb)
    Date
    2017
    Author
    Aghasi, Paul
    Gutmark, Ephraim
    Munday, David
    Metadata
    Show full item record
    Abstract
    Film cooling effectiveness is closely dependent on the geometry of the hole emitting the cooling film. These holes are sometimes quite expensive to machine by traditional methods, so 3D printed test pieces have the potential to greatly reduce the cost of film cooling experiments. What is unknown is the degree to which parameters like layer resolution and the choice among 3D printing technologies influence the results of a film cooling test. A new flat-plate film cooling facility employing oxygen-sensitive paint (OSP) verified by gas sampling and the mass transfer analogy and measurements both by gas sampling and OSP is verified by comparing measurements by both gas sampling and OSP. The same facility is then used to characterize the film cooling effectiveness of a diffuser-shaped film cooling hole geometry. These diffuser holes are then produced by a variety of additive manufacturing (AM) technologies with different build layer thicknesses. The objective is to determine if cheaper manufacturing techniques afford usable and reliable results. The coolant gas used is CO2 yielding a density ratio (DR) of 1.5. Surface quality is characterized by an optical microscope that measures surface roughness. Test coupons with rougher surface topology generally showed delayed blow off and higher film cooling effectiveness at high blowing ratios (BR) compared to the geometries with lower measured surface roughness. At the present scale, none of the additively manufactured parts consistently matched the traditionally machined part, indicating that caution should be exercised in employing additively manufactured test pieces in film cooling work.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4234336
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV