• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Numerical Investigation on Diffusion Slot Hole With Various Cross-Sectional End Shapes

    Thumbnail
    View/Open
    ht_139_09_091703.pdf (3.368Mb)
    Date
    2017
    Author
    An, Bai-Tao
    Liu, Jian-Jun
    Metadata
    Show full item record
    Abstract
    The diffusion hole constructed on a slot-type cross section has the potential to obtain high film cooling performance. However, the end shape of the cross section can greatly affect film cooling characteristics. This study examined eight cases of diffusion slot holes with various cross-sectional end shapes. The comparison of the eight diffusion slot holes and a typical fan-shaped hole was performed with a flat plate model using a three-dimensional (3D) steady computational fluid dynamics (CFD) method. The rectangular cross section had an aspect ratio of about 3.4. The end shape variation can be described based on sidewall contraction location, size, and form. The simulations were performed under an engine-representative condition of mainstream inlet Mach number 0.3 and turbulence intensity 5.2%. The simulated results showed that a strip separation bubble caused by inlet “jetting effect” occurs near the downstream wall of the diffusion slot hole and interacts with the diffusion flow. The different end shape of the rectangular cross section leads to different sidewall static pressure and exit velocity profiles, thereby produces three cooling effectiveness patterns, single-peak, bipeak, and tripeak patterns. The tripeak pattern produces higher cooling effectiveness and relatively uniform film coverage. The structure with moderate contraction and smooth transition on two sides of the downstream wall favors creation of a tripeak pattern. Compared with the fan-shaped hole, the discharge coefficient of diffusion slot hole is slightly small in low pressure ratio range, the pressure loss ratio has little difference.
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4234315
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV