• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Numerical Simulation of Evaporating Two-Phase Flow in a High-Aspect-Ratio Microchannel with Bends

    Thumbnail
    View/Open
    ht_139_08_080905.pdf (1.376Mb)
    Date
    2017
    Author
    Lee, Junsik
    Kim, Junsub
    Lim, Hyungsoo
    Bang, Je Sung
    Seo, Jeong Min
    Sohn, Jeong Lak
    Lee, Jungho
    Metadata
    Show full item record
    Abstract
    Effusion cooling is one of the attractive methods for next generation high-efficient gas turbine which has a very hot gas temperature above 1,600oC. For higher effectiveness of the air cooling, the air-cooled flow through effusion-holes does not penetrate into the mainstream flow but still remains within freestream boundary layer. So the air-cooled surface temperature maintains at relatively lower than film cooling. Effusion cooling is generally known as operating in small effusion-hole size which is less than 0.2 mm. This study is intended to examine optimum effusion-hole size of the microscale effusion cooling through flow visualization. The air flow through effusion-holes is visualized using an oil atomizer, a DSPP laser-sheet illumination, and a high-speed CCD imaging. The visualized results show flow patterns and characteristics with different blowing ratio, BR = ρcUc / ρ∞U∞, (BR = 0.17 and 0.53) and effusion-hole size (D = 0.2 mm, 0.5 mm and 1.0 mm). The flow visualization condition is fixed at the mainstream Reynolds number of 10,000 and hole-to-hole spacing of 4 (S/D = 4). For larger effusion-hole of 1.0 mm [(a) and (b)], the effusion flow can penetrate into boundary layer which exhibits a film cooling. However the effusion flow is observed to be remained within boundary layer which shows an effusion cooling for smaller effusion-hole of 0.2 mm [(e) and (f)]. In case of (c) and (d), a series of vortical structure is also observed to be within the boundary layer along the effusion flat plate. Note that the effusion-hole size of 0.5 mm can be a candidate for making effusion cooling possible. [This work was supported by National Research Council of Science and Technology (NST) grant funded by the Ministry of Science, ICT and Future Planning, Korea (Grant No. KIMM-NK203B).]
    URI
    http://138.201.223.254:8080/yetl1/handle/yetl/4234289
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV