Show simple item record

dc.contributor.authorLi, Wei
dc.contributor.authorZhang, Jingzhi
dc.contributor.authorBai, Guanghui
dc.contributor.authorXu, Jin-liang
dc.contributor.authorSimon, Terrence W.
dc.contributor.authorLi, Junye
dc.contributor.authorWei, Jin-jia
dc.date.accessioned2017-11-25T07:16:43Z
dc.date.available2017-11-25T07:16:43Z
dc.date.copyright2016/26/10
dc.date.issued2017
dc.identifier.issn0022-1481
dc.identifier.otherht_139_02_021501.pdf
dc.identifier.urihttp://138.201.223.254:8080/yetl1/handle/yetl/4234159
dc.description.abstractHeat transfer characteristics for condensation for R410A inside horizontal round (dh = 3.78 mm) and flattened tubes (aspect ratio (AR) = 3.07, 4.23, and 5.39) with larger horizontal than vertical dimensions at a saturation temperature of 320 K are investigated numerically. The flattened tube has flat upper and lower walls and circular end walls. The heat and mass transfer model for condensation is verified by comparing numerical heat transfer coefficients of round tubes with experimental data and empirical correlations. Liquid–vapor interfaces and local heat transfer coefficients are also presented to give a better understanding of the condensation process inside these tubes. The results indicate that local heat transfer coefficients increase with increasing mass flux, vapor quality, and aspect ratio. The enhancement of heat transfer coefficients for flattened tubes is more pronounced at higher mass flux and vapor quality values (about 1.5 times the heat transfer coefficients for round tubes when G = 1061 kg m−2 s−1, x ≥ 0.8). Unlike in the round tubes, the liquid film in the flattened tube accumulates at the sides of the bottom surface and at the middle of the top surface of the channels when vapor quality is low. Peak values of liquid film thickness in flattened tubes are obtained around angles about the centroid θ of 70 deg and 117 deg, where θ = 0 deg is upward.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Simulation of Condensation for R410A in Horizontal Round and Flattened Minichannels
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue2
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4034812
dc.journal.fristpage21501
dc.journal.lastpage021501-9
dc.treeJournal of Heat Transfer:;2017:;volume( 139 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record