Show simple item record

dc.contributor.authorChen, Xuelong
dc.contributor.authorSu, Zhongbo
dc.contributor.authorMa, Yaoming
dc.contributor.authorYang, Kun
dc.contributor.authorWen, Jun
dc.contributor.authorZhang, Yu
dc.date.accessioned2017-06-09T16:49:36Z
dc.date.available2017-06-09T16:49:36Z
dc.date.copyright2013/03/01
dc.date.issued2012
dc.identifier.issn1558-8424
dc.identifier.otherams-74833.pdf
dc.identifier.urihttp://onlinelibrary.yabesh.ir/handle/yetl/4217102
dc.description.abstractoughness height for heat transfer is a crucial parameter in the estimation of sensible heat flux. In this study, the performance of the Surface Energy Balance System (SEBS) has been tested and evaluated for typical land surfaces on the Tibetan Plateau on the basis of time series of observations at four sites with bare soil, sparse canopy, dense canopy, and snow surface, respectively. Both under- and overestimation at low and high sensible heat fluxes by SEBS was discovered. Through sensitivity analyses, it was identified that these biases are related to the SEBS parameterization of bare soil?s excess resistance to heat transfer (kB?1, where k is the von Kármán constant and B?1 is the Stanton number). The kB?1 of bare soil in SEBS was replaced. The results show that the revised model performs better than the original model.
dc.publisherAmerican Meteorological Society
dc.titleAn Improvement of Roughness Height Parameterization of the Surface Energy Balance System (SEBS) over the Tibetan Plateau
dc.typeJournal Paper
dc.journal.volume52
dc.journal.issue3
dc.journal.titleJournal of Applied Meteorology and Climatology
dc.identifier.doi10.1175/JAMC-D-12-056.1
dc.journal.fristpage607
dc.journal.lastpage622
dc.treeJournal of Applied Meteorology and Climatology:;2012:;volume( 052 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record