Show simple item record

dc.contributor.authorCunha, Ana Paula M. A.
dc.contributor.authorAlvalá, Regina C. S.
dc.contributor.authorSampaio, Gilvan
dc.contributor.authorShimizu, Marília Harumi
dc.contributor.authorCosta, Marcos Heil
dc.date.accessioned2017-06-09T16:49:18Z
dc.date.available2017-06-09T16:49:18Z
dc.date.copyright2013/12/01
dc.date.issued2013
dc.identifier.issn1558-8424
dc.identifier.otherams-74736.pdf
dc.identifier.urihttp://onlinelibrary.yabesh.ir/handle/yetl/4216994
dc.description.abstracthe reliability of predictions from climate and weather models is linked to an adequate representation of the land surface processes. To evaluate performance and to improve predictions, land surface models are calibrated against observed data. Despite an extensive literature describing methods of land surface model calibration, few studies have applied a calibration method for semiarid natural vegetation, especially for the semiarid northeast of Brazil, which presents caatinga as its natural vegetation. Caatinga is a highly dynamic ecosystem with the physics at the land surface?atmosphere interface still poorly understood. Therefore, in this study a multiobjective hierarchical method, which provides means to estimate optimal values of the model parameters through calibration, is evaluated. This method is applied to caatinga by using the Integrated Biosphere Simulator (IBIS). Results demonstrated that the calibrated set of vegetation parameters produced a considerably different energy balance from the default parameters. In general, the model was able to simulate the partition of the available energy into sensible and latent heat fluxes when the calibrated parameters were used. The IBIS model was not able to capture short-term, intense changes in latent heat flux from a dry condition to a wetter condition, however, even when the new set of calibrated parameters was used. Therefore, the parameter optimization may not be sufficient if processes are missing or misrepresented. This study is one of the first to understand the physics at the land surface?atmosphere interface in the caatinga ecosystem and to evaluate the ability of the IBIS model to represent the biophysical interactions in this important ecosystem.
dc.publisherAmerican Meteorological Society
dc.titleCalibration and Validation of the Integrated Biosphere Simulator (IBIS) for a Brazilian Semiarid Region
dc.typeJournal Paper
dc.journal.volume52
dc.journal.issue12
dc.journal.titleJournal of Applied Meteorology and Climatology
dc.identifier.doi10.1175/JAMC-D-12-0190.1
dc.journal.fristpage2753
dc.journal.lastpage2770
dc.treeJournal of Applied Meteorology and Climatology:;2013:;volume( 052 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record