Bore Height Measurement with Improved Wavestaff
Abstract
An improved capacitance wavestaff is described and used to measure wave height transformation in a surf zone; and the assumption is tested that wave height decays linearly across a surf zone. Acceptable frequency response in the instrument could be obtained only if sensor wires were smaller than or equal to 0.35 mm in diam. Simultaneous measurements of wave height were taken at points distributed across a surf zone during four field experiments at Virginia Beach, Virginia. Pairs of wavestaffs were repositioned along a line perpendicular to the shore line. Wave height decay across this surf zone was found to be nonlinear, and the observed pattern appears to be categorizable into three zones: (1) One in which there is a rapid decay in height due to turbulence induced by the breaking process; (2) one in which there is a nearly constant decay due to a balance between turbulence and wave shoaling affects; and (3) one in which there is a rapid decay of remaining wave energy as a wave propagates up the beach slope against the force of gravity. Energy is dissipated less rapidly by spilling breakers than plunging breakers, and, thus, spilling breakers produce greater runup at the shore line.