Show simple item record

dc.contributor.authorEhsan Kabiri Rahani
dc.contributor.authorAli Bakhshi
dc.contributor.authorAli Akbar Golafshani
dc.date.accessioned2017-05-08T21:00:52Z
dc.date.available2017-05-08T21:00:52Z
dc.date.copyrightApril 2009
dc.date.issued2009
dc.identifier.other%28asce%290733-9445%282009%29135%3A4%28425%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/35399
dc.description.abstractStructural control using energy dissipater devices is emerging as a heavily researched strategy in earthquake engineering. Among several control systems, semiactive control is usually possible and efficient. In this research, a semiactive energy dissipating bracing system based on a viscous damper is proposed. In the conventional bracing systems, it is assumed that the braces can buckle under compression. Therefore, a semiactive on-off brace strategy is implemented to improve the conventional brace performance. Further, an energy absorbing mechanism is implemented. In the proposed system, the buckling of the member is prevented by implementing a one-way valve device. The permanent story drifts at the end of excitations are negligible. In this mechanism, any actuator and/or large power supply are not needed, instead, just battery-size power supplies to switch the one-way valve mechanical system on or off. The developed mechanism is composed of a viscous damper, a length correction control system, and a normal wind bracing on each floor. Despite the fact that this system does not get control command from the outside, it is called a semiactive control system. The hysteresis loop of the braces is almost similar to ductile tensile steel members. Therefore, the system is full capacity design. Nonlinear dynamic analysis of the system has been carried out and structural behavior has been investigated. In addition, damage indices are determined in order to compare the viscous tensile bracing system with the conventional bracing systems.
dc.publisherAmerican Society of Civil Engineers
dc.titleSemiactive Viscous Tensile Bracing System
dc.typeJournal Paper
dc.journal.volume135
dc.journal.issue4
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(2009)135:4(425)
dc.treeJournal of Structural Engineering:;2009:;Volume ( 135 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail
This item appears in the following Collection(s)

Show simple item record