Show simple item record

dc.contributor.authorDarren Vian
dc.contributor.authorMichel Bruneau
dc.contributor.authorRonny Purba
dc.date.accessioned2017-05-08T21:00:50Z
dc.date.available2017-05-08T21:00:50Z
dc.date.copyrightMarch 2009
dc.date.issued2009
dc.identifier.other%28asce%290733-9445%282009%29135%3A3%28221%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/35374
dc.description.abstractThis paper presents a comparison of analytical and experimental results from an investigation of specially detailed ductile perforated steel plate shear walls (SPSWs). These SPSWs had low yield strength steel infill panels, anchor beams with reduced beam sections connections, and were specially detailed to accommodate utility passage through the wall while remaining ductile. Finite-element models of full SPSWs and subelement strips are developed using the finite element software package ABAQUS/Standard to facilitate a comparison with experimental results and to investigate the influence of localized distribution of panel stress and strain between perforations. Based on the analytical and experimental results, recommendations for the design of these special detailed perforated SPSWs are presented.
dc.publisherAmerican Society of Civil Engineers
dc.titleSpecial Perforated Steel Plate Shear Walls with Reduced Beam Section Anchor Beams. II: Analysis and Design Recommendations
dc.typeJournal Paper
dc.journal.volume135
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(2009)135:3(221)
dc.treeJournal of Structural Engineering:;2009:;Volume ( 135 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record