| dc.contributor.author | N. Dadhiala | |
| dc.contributor.author | K. Koo | |
| dc.contributor.author | J. K. Spelt | |
| dc.date.accessioned | 2017-05-08T21:00:34Z | |
| dc.date.available | 2017-05-08T21:00:34Z | |
| dc.date.copyright | June 2008 | |
| dc.date.issued | 2008 | |
| dc.identifier.other | %28asce%290733-9445%282008%29134%3A6%281046%29.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/35258 | |
| dc.description.abstract | An experimental study was conducted to investigate whether existing industry design procedures for tight-fitting metal plate connector truss joints can be applied to the design of joints made with round-end webs. Four joint configurations were tested with a range of connector-plate sizes: 45° with web in tension, 45–45° with one web in compression and the other in tension, 45–90° with the 45° web in compression and the 90° web in tension, and 45° with the web under compression. In total, 87 tight-fitting and 171 round-end joints were tested. As expected the tight-fitting joints were stronger and stiffer than round-end joints. Both the shear strength of the metal plate connector and the teeth pullout strength were smaller in the round-end joints than in the tight-fitting joints. The line contacts between the round-end webs in compression produced greater crushing of the wood, causing buckling of the connector plates, and reducing the ultimate loads on these joints. Design guidelines are suggested for round-end joints. | |
| dc.publisher | American Society of Civil Engineers | |
| dc.title | Quasi-Static Strengths and Failure Modes of Tight-Fitting and Round-End Metal-Plate Wooden Truss Joints | |
| dc.type | Journal Paper | |
| dc.journal.volume | 134 | |
| dc.journal.issue | 6 | |
| dc.journal.title | Journal of Structural Engineering | |
| dc.identifier.doi | 10.1061/(ASCE)0733-9445(2008)134:6(1046) | |
| dc.tree | Journal of Structural Engineering:;2008:;Volume ( 134 ):;issue: 006 | |
| dc.contenttype | Fulltext | |