Show simple item record

dc.contributor.authorH. R. Milner
dc.contributor.authorJan Peczkis
dc.date.accessioned2017-05-08T21:00:15Z
dc.date.available2017-05-08T21:00:15Z
dc.date.copyrightJune 2007
dc.date.issued2007
dc.identifier.other%28asce%290733-9445%282007%29133%3A6%28855%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/35052
dc.description.abstractThe difficulties of modeling the vertical flexure of mechanically fastened wooden ship hulls as that of box beams, a mainstay of naval architecture when applied to iron and steel ships, can largely be overcome by factoring the incomplete composite action of timber components in terms of a reduced shear modulus, an increased shear lag, and a reduced sectional area in tension (owing to butt joints). Sample computations on a large wooden hull indicate that its deflection can be limited to about twice that of a completely composite hull if stiff fasteners (drift pins) are used at a much greater density than is typical of traditional construction. The lengths of timber pieces become severely limiting only if they are below
dc.publisherAmerican Society of Civil Engineers
dc.titleWooden Ship Hulls as Box Girders with Multiple Interlayer Slip
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue6
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(2007)133:6(855)
dc.treeJournal of Structural Engineering:;2007:;Volume ( 133 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record