Show simple item record

dc.contributor.authorHassan H. Abbas
dc.contributor.authorRichard Sause
dc.contributor.authorRobert G. Driver
dc.date.accessioned2017-05-08T21:00:09Z
dc.date.available2017-05-08T21:00:09Z
dc.date.copyrightMarch 2007
dc.date.issued2007
dc.identifier.other%28asce%290733-9445%282007%29133%3A3%28347%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/34996
dc.description.abstractThis paper presents theoretical, experimental, and finite-element analysis results for the linear elastic behavior of corrugated web steel I-girders under in-plane loads. A typical corrugated web steel I-girder consists of two steel flanges welded to a corrugated steel web. Previous research has shown that a corrugated web I-girder under primary moment and shear cannot be analyzed using conventional beam theory alone, and a flange transverse bending analysis is required. A theoretical method, the fictitious load method, is presented herein as an analytical tool for quantifying flange transverse bending in corrugated web I-girders. To validate this method, four-point bending experimental results for a large-scale corrugated web I-girder are presented. The measured flange transverse displacements and flange stresses were in good agreement with the theoretical results especially in regions of constant shear. To gain additional insight, finite- element analysis results for the test girder are presented, and compared to both the experimental and theoretical results.
dc.publisherAmerican Society of Civil Engineers
dc.titleAnalysis of Flange Transverse Bending of Corrugated Web I-Girders under In-Plane Loads
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(2007)133:3(347)
dc.treeJournal of Structural Engineering:;2007:;Volume ( 133 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record