Now showing items 4061-4080 of 5605

    • Dynamic Analysis of Noncollocated Flexible Arms and Design of Torque Transmission Mechanisms 

      Jahng-Hyon Park; Haruhiko Asada (The American Society of Mechanical Engineers (ASME), 1994)
      A new actuation method for one-link flexible arms is presented. The endpoint control of a flexible arm has been known as a nonminimum phase system due to the noncollocated sensor and actuator. ...
    • On the Stability of PD Control for a Two-Link Rigid-Flexible Manipulator 

      Ahmet S. Yigit (The American Society of Mechanical Engineers (ASME), 1994)
      Controller design for a rigid-flexible two-link manipulator is considered. Robustness of independent joint PD control is investigated. It has been shown that the stability of independent joint ...
    • Efficient Dynamic Simulation of Multiple Chain Robotic Mechanisms 

      K. W. Lilly; D. E. Orin (The American Society of Mechanical Engineers (ASME), 1994)
      An efficient O(mN) algorithm for the dynamic simulation of simple closed-chain robotic mechanisms is presented in this paper, where m is the number of chains, and N is the number of links ...
    • Discrete Time Noncollocated Control of Flexible Mechanical Systems Using Time Delay 

      M. S. Kang; B. Yang (The American Society of Mechanical Engineers (ASME), 1994)
      This paper studies discrete time noncollocated control of flexible mechanical systems. A sampled data system with one sensor and one actuator is formulated. Specific time delay is introduced in ...
    • The Dynamic Effects of Tire Lag on Simulation Yaw Rate Predictions 

      G. J. Heydinger; W. R. Garrott; J. P. Chrstos; D. A. Guenther (The American Society of Mechanical Engineers (ASME), 1994)
      Two vehicle stability and control simulations, IDSFC and VDANL, are shown to have substantial discrepancies in predicted yaw rate transient response. J-turn and sinusoidal sweep steering maneuvers, ...
    • A Time-Domain Inverse Dynamic Tracking Control of a Single-Link Flexible Manipulator 

      Dong-Soo Kwon; Wayne J. Book (The American Society of Mechanical Engineers (ASME), 1994)
      A manipulator system with a large workspace volume and high payload capacity has greater link flexibility than do typical industrial robots and teleoperators. If link flexibility is significant, ...
    • Resolved-Mode Teleoperated Control of Heavy-Duty Hydraulic Machines 

      N. Sepehri; P. D. Lawrence; F. Sassani; R. Frenette (The American Society of Mechanical Engineers (ASME), 1994)
      This paper addresses the control problem for a class of heavy-duty hydraulic machines in order to achieve coordinated motion control of the implement. A model and sensor-based control algorithm ...
    • Predictive Controller and Estimator for NASA Deep Space Network Antennas 

      W. Gawronski (The American Society of Mechanical Engineers (ASME), 1994)
      This paper presents a modified output prediction procedure, and a new controller design based on the predictive control law. Also, a predictive estimator is developed for implementing the ...
    • Direct Adaptive Rapid Tracking of Short Complex Trajectories 

      C. C. H. Ma (The American Society of Mechanical Engineers (ASME), 1994)
      A direct adaptive rapid tracking methodology for tracking complex trajectories in short-duration, linear, possibly slowly varying, and/or imprecisely known, industrial processes is proposed. The ...
    • Estimation of Steady-State Optimal Filter Gain From Nonoptimal Kalman Filter Residuals 

      Chung-Wen Chen; Jen-Kuang Huang (The American Society of Mechanical Engineers (ASME), 1994)
      This paper proposes a new algorithm to estimate the optimal steady-state Kalman filter gain of a linear, discrete-time, time-invariant stochastic system from nonoptimal Kalman filter residuals. ...
    • A Novel PID Configuration for Speed and Position Control 

      Romano M. De Santis (The American Society of Mechanical Engineers (ASME), 1994)
      A Proportional-Integral-Derivative (PID) configuration for speed and position control, of which the gains influence input/output and sensitivity properties with a higher degree of decoupling than ...
    • A New Look at PID-Controller Tuning 

      David W. Pessen (The American Society of Mechanical Engineers (ASME), 1994)
      The well-known Ziegler-Nichols method for tuning controllers has been used for 50 years. Since it is still popular, the time is ripe for a reappraisal. It is shown that the Ziegler-Nichols ...
    • Controlling Chaos: The Example of an Impact Oscillator 

      Jayant R. Kalagnanam (The American Society of Mechanical Engineers (ASME), 1994)
      The OGY algorithm (Ott et al., 1990) allows the conversion of a chaotic attractor to any one of a large number of periodic orbits by making small time-dependent perturbations of an available ...
    • Lagrangian Bond Graphs for Solid Continuum Dynamics Modeling 

      E. P. Fahrenthold; J. D. Wargo (The American Society of Mechanical Engineers (ASME), 1994)
      The limitations of existing continuum bond graph modeling techniques have effectively precluded their use in large order problems, where nonrepetitive graph structures and causal patterns are ...
    • Analytic Loop Shaping Methods in Quantitative Feedback Theory 

      D. F. Thompson; O. D. I. Nwokah (The American Society of Mechanical Engineers (ASME), 1994)
      Quantitative Feedback Theory (QFT), a robust control design method introduced by Horowitz, has been shown to be useful in many cases of multi-input, multi-output (MIMO) parametrically uncertain ...
    • User-Adaptable Comfort Control for HVAC Systems 

      Clifford C. Federspiel; Haruhiko Asada (The American Society of Mechanical Engineers (ASME), 1994)
      This paper describes a new approach to the control of heating, ventilating, and air-conditioning (HVAC) systems. The fundamental concept of the new approach is that the controller learns to ...
    • Specular Reflection Probability in the Certainty Grid Representation 

      Jong Hwan Lim; Dong Woo Cho (The American Society of Mechanical Engineers (ASME), 1994)
      A new method for solving the specular reflection problem of sonar systems has been developed and implemented. This method, the specular reflection probability method, permits the robot to construct ...
    • Electro-Rheological Fluids: A Systematic Approach to Classifying Modes of Operation 

      R. Stanway; J. L. Sproston (The American Society of Mechanical Engineers (ASME), 1994)
      In this paper, the authors describe a systematic procedure for classifying the modes of operation of ER fluids. The classification is achieved by treating an ER device as a generalized modulator ...
    • Robust Adaptive Controllers for Interconnected Mechanical Systems: Influence of Types of Interconnections on Time-Invariant and Time-Varying Systems 

      Sunil K. Singh; Lin Shi (The American Society of Mechanical Engineers (ASME), 1994)
      We investigate robust adaptive controller designs for interconnected systems when no exact knowledge about the structure of the nonlinear interconnections between various subsystems is available. ...
    • A Robust Method to Determine the Coordinates of a Wave Source for 3-D Position Sensing 

      Fernando Figueroa; Ajay Mahajan (The American Society of Mechanical Engineers (ASME), 1994)
      This work addresses a method for location of a wave source by observing the wave as it reaches various observation points (receivers), or conversely, this is also a method for location of a ...