Journal of Dynamic Systems, Measurement, and Control: Recent submissions
Now showing items 1341-1360 of 5605
-
Use of State Observers in the Optimal Feedback Control of Automated Transit Vehicles
(The American Society of Mechanical Engineers (ASME), 1973)The theory of optimal control and the theory of observers is applied to the design of feedback systems for longitudinal control of vehicles in automated, high-capacity transit systems. The ... -
On the Art of Advancing The Science of Fluidics
(The American Society of Mechanical Engineers (ASME), 1973)Limitations in our understanding of the fluid dynamic phenomena encountered in fluidic elements and the resulting difficulty of the quantitative characterization for simple cataloging of the ... -
Pressure and Flow Recovery Characteristics of a Single Fluid Amplifier Receiver With Offset Bounded Jets
(The American Society of Mechanical Engineers (ASME), 1973) -
Sinusoidal Excitation of a Free Turbulent Jet With Constant Amplitude Transverse Pressure Gradients Near the Nozzle Exit: Part II: An A-C Fluidic Model for the Jet Gain
(The American Society of Mechanical Engineers (ASME), 1973)A free turbulent jet is perturbed transverse to the flow direction by a sinusoidal pressure gradient near the nozzle exit. An a-c model for the jet gain, based upon the control region dynamics ... -
Jet-Driven Cylindrical Cavity Oscillators
(The American Society of Mechanical Engineers (ASME), 1973)The effects of cavity diameter, jet-exit distance, and flow rate on the performance of a jet-driven cylindrical cavity oscillator are investigated experimentally in this study. The cavity oscillator ... -
Hydraulic Fluidics
(The American Society of Mechanical Engineers (ASME), 1973)Fluidic technology is equally applicable to liquid and gaseous operation, yet the bulk of the literature to date is concerned with the latter. This paper describes some of the unique effects ... -
An Analytical and Empirical Basis for the Design of Turbulence Amplifiers: Part II: Empirical Relationships and Design Procedure
(The American Society of Mechanical Engineers (ASME), 1973)This paper is a direct extension of Part I. The relationships important to turbulence amplifier characteristics but not amenable to direct analysis are empirically determined in this part. These ... -
Development of a Submerged Round Laminar Jet From an Initially Parabolic Profile
(The American Society of Mechanical Engineers (ASME), 1973)The region near the nozzle exit of laminar free jets is of interest to those involved with the design of fluid control and free jet sensing devices often applied in low cost automation. An ... -
Sinusoidal Excitation of a Free Turbulent Jet With Constant Amplitude Transverse Pressure Gradients Near the Nozzle Exit: Part I: Measurement of Mean Shear Velocities
(The American Society of Mechanical Engineers (ASME), 1973)A free turbulent jet is perturbed transverse to the flow direction by a sinusoidal pressure gradient near the nozzle exit. Velocities in the jet are determined by hot wire anemometer measurements. ... -
An Analytical and Empirical Basis for the Design of Turbulence Amplifiers: Part I: Analysis and Experimental Confirmation
(The American Society of Mechanical Engineers (ASME), 1973)The design of turbulence amplifiers is given a rational basis by identifying the critical parameter groups necessary to completely specify the performance of a given element, deriving by analysis ... -
Fluidic Control of a Hydrostatic Transmission in a Vehicle Propulsion System
(The American Society of Mechanical Engineers (ASME), 1973)A vehicle propulsion system is considered which consists of an engine, hydrostatic transmission, and automatic controller. Control requirements are established for optimum or near optimum operation ... -
Turn-ON and Turn-OFF Times for a Laminar Jet
(The American Society of Mechanical Engineers (ASME), 1973)Experimental results of the speed of travel of a disturbance in front of suddenly switched-on and switched-off submerged laminar jets are presented. The results show that the time lag for a ... -
Discussion: “Multiport Models in Mechanics” (Rosenberg, R. C., 1972, ASME J. Dyn. Syst., Meas., Control, 94, pp. 206–212)
(The American Society of Mechanical Engineers (ASME), 1973) -
Discussion: “Jet-Driven Cylindrical Cavity Oscillators” (Franke, M. E., Jones, III, G., and Olsen, W. A., 1973, ASME J. Dyn. Syst., Meas., Control, 95, pp. 125–131)
(The American Society of Mechanical Engineers (ASME), 1973) -
Discussion: “Optimum Boundaries for Elliptic Systems” (Hari, Y., 1972, ASME J. Dyn. Syst., Meas., Control, 94, pp. 159–164)
(The American Society of Mechanical Engineers (ASME), 1973) -
Closure to “Discussion of ‘Multiport Models in Mechanics’” (1973, ASME J. Dyn. Syst., Meas., Control, 95, p. 238)
(The American Society of Mechanical Engineers (ASME), 1973) -
Modal Control Theory and Applications
(The American Society of Mechanical Engineers (ASME), 1973) -
Discussion: “A Definition of the Bond Graph Language” (Rosenberg, R. C., and Karnopp, D. C., 1972, ASME J. Dyn. Syst., Meas., Control, 94, pp. 179–182)
(The American Society of Mechanical Engineers (ASME), 1973) -
Discussion: “An Obscure Influence in the Golf Shot” (Williams, Jr., A. J., 1972, ASME J. Dyn. Syst., Meas., Control, 94, pp. 289–295)
(The American Society of Mechanical Engineers (ASME), 1973) -
Discussion: “Fluidic Control of a Hydrostatic Transmission in a Vehicle Propulsion System” (Reid, K. N., and Woods, R. L., 1973, ASME J. Dyn. Syst., Meas., Control, 95, pp. 114–123)
(The American Society of Mechanical Engineers (ASME), 1973)