Journal of Structural Engineering: Recent submissions
Now showing items 941-960 of 10765
-
Radiata Pine and Douglas Fir Timber Steel Encased Columns Subjected to Concentric and Eccentric Loading
(ASCE, 2021-11-26)Composite timber steel encased columns comprising low-grade coniferous softwood radiata pine (Pinus radiata) (MGP10 grade) and Douglas fir (Pseudotsuga menziesii) (F7 grade) with encased steel bars (yield strength of ... -
Simplified Mechanics-Based Approach for the Seismic Assessment of Corroded Reinforced Concrete Structures
(ASCE, 2021-12-27)The durability of older reinforced concrete structures is significantly affected by corrosion of the steel reinforcing bars, and assessing the seismic capacity of such corroded RC structures is a challenging task. A ... -
A New Finite Element–Based Methodology for Earthquake Simulation of Large-Scale Urban Areas
(ASCE, 2022-02-02)This paper presents a model to quantify the functionality of the physical systems at urban scales using a finite element–based approach. The methodology identifies the functionality of physical systems within an urban area ... -
Load-Effect Separation of a Large-Span Prestressed Structure Based on an Enhanced EEMD-ICA Methodology
(ASCE, 2021-12-22)Prestressed structures have gained popularity in large-span buildings due to their great spanning capacity and light self-weights. This kind of structure is normally subjected to multiple types of loads, such as temperature ... -
Experiment and Analysis of Seismically Isolated Single-Layer Cylindrical Reticulated Shell Structure
(ASCE, 2022-01-18)To explore the seismic response, influence mechanism, and failure of long-span spatial structures with three-dimensional seismic excitations in a strong earthquake, 1/6-scale shaking-table tests of single-layer cylindrical ... -
Calibration of Resistance Factor for Self-Tapping Screws in Canada
(ASCE, 2022-01-07)Under the load and resistance factor design philosophy used in North America, building codes structures are designed using load and resistance factors calibrated to a target reliability level. Despite this, few attempts ... -
Upper Limit of Aerodynamic Forces for Inelastic Wind Design
(ASCE, 2021-11-26)Due to the increasing tendency to construct taller and more slender buildings, the need to address aerodynamic and induced dynamic forces (inertial forces) under both service and strength-level wind loads has become more ... -
Development and Experimental Validation of Dissipative Embedded Column Base Connections for Enhanced Seismic Performance of Steel Moment-Resisting Frames
(ASCE, 2021-12-20)This paper proposes a novel embedded column base (ECB) connection that defies the current paradigm in capacity-designed steel moment-resisting frames (MRFs) where column bases have been traditionally considered as ... -
Machine Learning–Based Hysteretic Lateral Force-Displacement Models of Reinforced Concrete Columns
(ASCE, 2021-12-23)Hysteretic lateral force-displacement (HLFD) models are important for efficient structural analysis under cyclic loading (e.g., earthquakes). This paper proposes a novel machine learning (ML)-based HLFD model, referred ... -
A Procedure for Performing Nonlinear Pushover Analysis for Tsunami Loading to ASCE 7
(ASCE, 2021-11-26)The new ASCE 7-16 Chapter 6 offers a comprehensive and practical methodology for the design of structures for tsunami loads and effects. While it provides prescriptive tsunami loading and design requirements, Chapter 6 ... -
Seismic Performance of Interior Reinforced Concrete Beam–Column Joint with Corroded Reinforcement
(ASCE, 2021-11-26)This study presented an experimental and analytical investigation on the seismic behavior of a reinforced concrete (RC) interior joint with corroded reinforcements. A total of eight RC interior joints with similar reinforcing ... -
Rational Robustness Design of Multistory Building Structures
(ASCE, 2021-12-17)This paper presents concepts and methods developed over the past two decades for the rational and practical robustness design of multistory building structures. The consideration of sudden column loss as an event-independent ... -
Out-of-Plane Behavior of URM Infill: Accuracy of Available Capacity Models
(ASCE, 2021-12-23)The aim of this paper is to check the accuracy of analytical capacity models available for the prediction of out-of-plane strength of unreinforced masonry (URM) infill walls. The accuracy of the available models is checked ... -
Behavior and Design of Cold-Formed Steel Web-Stiffened Channels under Concentrated Bearing Loads
(ASCE, 2021-12-23)This study focused on the web crippling and design of web-stiffened channel sections made of cold-formed steel (CFS). CFS web-stiffened channels are expected to have higher buckling loads under compression and bending ... -
Experimental Investigation of the Structural Response of a Steel-Framed Building Subjected to Traveling Fire
(ASCE, 2021-11-25)This paper presents experimental investigations on the thermal response and structural behavior of a full-scale, 2-story, steel-framed building exposed to traveling fire. In this test protocol, the fuel bed consisted of ... -
Shear Capacity of Cold-Formed Steel Channels with Edge-Stiffened Web Holes, Unstiffened Web Holes, and Plain Webs
(ASCE, 2021-11-25)In this paper, a total of 254 results comprising 30 shear tests and 224 finite element (FE) analysis results are reported. Simply supported test specimens of cold-formed steel (CFS) channels with aspect ratios of 1.0 and ... -
Flexural Behavior and Design of Ultrahigh-Performance Concrete Beams
(ASCE, 2022-01-28)Beams made of ultrahigh-performance concrete (UHPC), a fiber-reinforced concrete with high compressive strength and tensile strain-hardening characteristics, exhibit flexural behaviors that are different than those ... -
Horizontal Collapse Propagation of Concrete Flat Slabs Supported on Columns
(ASCE, 2021-11-24)The progressive collapse of the World Trade Center showed the devastating consequences of pancake-type collapses, triggering significant research on failed-floor impacts for different forms of construction. In current ... -
The Total Collapse of the Twin Towers: What It Would Have Taken to Prevent It Once Collapse Was Initiated
(ASCE, 2021-11-30)It is generally taken as a given that there is no reasonable design concept that could have prevented the collapse of the Twin Towers, once it was initiated, from progressing all the way down to the ground. This view is ... -
Modeling Nonstationary Non-Gaussian Hurricane Wind Velocity and Gust Factor
(ASCE, 2021-11-23)This study estimated the wind gust factor and turbulence intensity for hurricane winds that are modeled as a nonstationary non-Gaussian process. The estimation considered the time-varying mean wind velocity, and the ...