Journal of Structural Engineering: Recent submissions
Now showing items 4941-4960 of 10765
-
Influence of Base Plate Flexibility on the Fatigue Performance of Welded Socket Connections
(American Society of Civil Engineers, 2008)This study investigates the effect of base plate flexibility on the behavior and fatigue performance of welded socket connections commonly used in sign support structures. The results of a three specimen static load testing ... -
Plastic Axial Load and Moment Interaction Curves for Fire-Exposed Steel Sections with Thermal Gradients
(American Society of Civil Engineers, 2008)Current practice for the design of steel beam-columns (i.e., members under combined axial load and bending) subject to fire is to calculate the capacity of these members assuming a uniform temperature distribution through ... -
Flexural Behavior of Nonposttensioned and Posttensioned Concrete-Filled Circular Steel Tubes
(American Society of Civil Engineers, 2008)Concrete-filled steel tubes (CFTs) have recently been used for columns and bridge piers, especially in seismic regions, for their enhanced strength and ductility over the conventional steel and concrete construction. This ... -
Energy Index Method: Technique for Identification of Structural Damages
(American Society of Civil Engineers, 2008)A structural damage detection method based on the change of strain energy in each element before and after the occurrence of damage is presented. The proposed method can localize and quantify both single and multiple ... -
Component and Cladding Wind Loads for Soffits
(American Society of Civil Engineers, 2008)The wind induced failure of soffits of low rise structures is a failure mechanism commonly observed in post hurricane damage investigations. The failure of the soffits has the potential to allow both wind and water to enter ... -
Closure to “Stability and Ductility of Thin-Walled Circular Steel Columns under Cyclic Bidirectional Loading” by Yoshiaki Goto, Kunsheng Jiang, and Makoto Obata
(American Society of Civil Engineers, 2008) -
Inelastic Displacement Ratios of Degrading Systems
(American Society of Civil Engineers, 2008)Seismic code provisions in several countries have recently adopted the new concept of performance-based design. New analysis procedures have been developed to estimate seismic demands for performance evaluation. Most of ... -
Damage Identification of Shear Connectors with Wavelet Packet Energy: Laboratory Test Study
(American Society of Civil Engineers, 2008)Shear connectors are widely used to link the slab and girders together in slab-on-girder structures. Assessment of the integrity of shear connectors is an important issue in the maintenance and health monitoring of such ... -
Dynamic Testing of Alfred Zampa Memorial Bridge
(American Society of Civil Engineers, 2008)This paper describes a set of dynamic field tests performed on the Alfred Zampa Memorial Bridge (AZMB), also known as the New Carquinez Bridge, which is located -
Quasi-Static Strengths and Failure Modes of Tight-Fitting and Round-End Metal-Plate Wooden Truss Joints
(American Society of Civil Engineers, 2008)An experimental study was conducted to investigate whether existing industry design procedures for tight-fitting metal plate connector truss joints can be applied to the design of joints made with round-end webs. Four joint ... -
Assessment of ASCE 7 Standard Wind Load Factors for Tall Building Response Estimates
(American Society of Civil Engineers, 2008)Wind load factors incorporated in the ASCE 7-05 standard are based on rough approximations of wind effects and the uncertainties inherent in them. These factors are routinely applied to tall building design, even though ... -
Specializing Park’s Compressive Membrane Theory
(American Society of Civil Engineers, 2008)Park’s compressive membrane theory has been used for many years to predict the capacity of laterally edge restrained reinforced concrete (LERRC) thin slabs. This note examines his compressive membrane theory and presents ... -
Discussion of “Stability and Ductility of Thin-Walled Circular Steel Columns under Cyclic Bidirectional Loading” by Yoshiaki Goto, Kunsheng Jiang, and Makoto Obata
(American Society of Civil Engineers, 2008) -
Estimation of Cumulative Deformation Capacity of Buckling Restrained Braces
(American Society of Civil Engineers, 2008)Recently, passive vibration control design has gained popularity. The aim of this design is to absorb most of the seismic energy by using additional dampers while maintaining the elasticity of the main structure. Buckling ... -
Ambient Vibration Analysis with Subspace Methods and Automated Mode Selection: Case Studies
(American Society of Civil Engineers, 2008)This study presents an investigation of the performance of subspace techniques for modal identification using ambient vibration measurements. Several models and structures characterized by increasing degrees of complexity ... -
Unbalanced Moment Resistance in Slab-Column Joints: Analytical Assessment
(American Society of Civil Engineers, 2008)ACI 318-05 considers that unbalanced moment, -
Confinement Reinforcement Design for Reinforced Concrete Columns
(American Society of Civil Engineers, 2008)This paper presents new equations for the design of confinement reinforcement for ductile earthquake-resistant rectangular and circular columns based on performance measured in terms of curvature demand. These equations ... -
High-Strength Concrete Columns Reinforced with Prefabricated Cage System
(American Society of Civil Engineers, 2008)A new steel reinforcement system is introduced to be used in concrete columns. This new reinforcement, named Prefabricated Cage System (PCS), is an alternative to the rebar cage used in traditional reinforced concrete for ... -
Tubular Links for Eccentrically Braced Frames. II: Experimental Verification
(American Society of Civil Engineers, 2008)This paper describes the results of an experimental study to verify proposed design requirements for eccentrically braced frame links with hollow rectangular (i.e., tubular) cross sections. Twelve primary link specimens ... -
Behavior of Steel Beam-to-Column Joints at Elevated Temperature: Experimental Investigation
(American Society of Civil Engineers, 2008)Although beam-to-column joints are a critical part of steel and composite framed structures, very few tests have been conducted under fire conditions. Of the tests conducted, only a limited range of joint types has been ...