Journal of Structural Engineering: Recent submissions
Now showing items 4841-4860 of 10765
-
Fully Reversed Cyclic Loading of Shear Walls Fastened with Engineered Nails
(American Society of Civil Engineers, 2009)Fifteen shear walls, each constructed with either conventional or engineered sheathing nails, were tested under fully reversed cyclic loads. Four types of conventional nails (named 0.113, 0.113R, 0.131, and 0.148 nails) ... -
Special Perforated Steel Plate Shear Walls with Reduced Beam Section Anchor Beams. II: Analysis and Design Recommendations
(American Society of Civil Engineers, 2009)This paper presents a comparison of analytical and experimental results from an investigation of specially detailed ductile perforated steel plate shear walls (SPSWs). These SPSWs had low yield strength steel infill panels, ... -
Closure to “Structural Monitoring and Integrity Assessment of Medieval Towers” by Alberto Carpinteri and Giuseppe Lacidogna
(American Society of Civil Engineers, 2009) -
Discussion of “Structural Monitoring and Integrity Assessment of Medieval Towers” by Alberto Carpinteri and Giuseppe Lacidogna
(American Society of Civil Engineers, 2009) -
Finite-Strip Method for the Analysis of Cracked Plates with Application to Plate-Girder Bridges
(American Society of Civil Engineers, 2009)The finite-strip method (FSM) is one of the most efficient methods for structural analysis of bridges, reducing the time required for analysis without affecting the degree of accuracy. FSM is therefore an ideal platform ... -
Lateral Performance of Nonsymmetric Diagonal-Braced Wood Shear Walls
(American Society of Civil Engineers, 2009)The lateral performance of structurally nonsymmetric diagonal-braced wood shear walls used in post-and-beam timber buildings was investigated with laboratory testing and computer modeling. Monotonic and reversed cyclic ... -
Testing and Analysis of Steel Pipes under Bending, Tension, and Internal Pressure
(American Society of Civil Engineers, 2009)This paper reports a full-scale experimental program consisting of six pipe specimens made of X65 material (specified minimum yield -
Application of Energy Balance Concept in Seismic Evaluation of Structures
(American Society of Civil Engineers, 2009)The objective of this paper is to present a seismic evaluation procedure based on an energy balance concept. The method is based on a framework that utilizes energy demand and capacity diagrams. The skeleton force–displacement ... -
Prefabricated Steel Stair Performance under Combined Seismic and Gravity Loads
(American Society of Civil Engineers, 2009)Tests were performed on full-size prefabricated steel stair assemblies to assess seismic interstory drift response combined with factored gravity loads. The stair assemblies were production-run units of a standard system ... -
Performance-Based Wind Engineering for Wood-Frame Buildings
(American Society of Civil Engineers, 2009)The majority of buildings and the vast majority of residential structures in North America are constructed using light-frame wood. Many of these structures are subjected to high winds along the eastern seaboard and gulf ... -
Seismic History Analysis of Asymmetric Buildings with Soil–Structure Interaction
(American Society of Civil Engineers, 2009)An efficient approximate method that uses the multi-degrees-of-freedom (MDOF) modal equations of motion for the seismic response history analysis of asymmetric elastic buildings with soil–structure interaction (SSI) is ... -
Hysteretic Model for Reinforced Concrete Columns Including the Effect of Shear and Axial Load Failure
(American Society of Civil Engineers, 2009)Recent strong earthquakes have shown that column failure is the primary cause of collapse in many existing older buildings and bridges. The main objective of this paper is to develop a macromodel to simulate the cyclic ... -
Framework for Multihazard Risk Assessment and Mitigation for Wood-Frame Residential Construction
(American Society of Civil Engineers, 2009)Wood-frame residential construction represents a major investment in the United States, which, when exposed to hurricanes, earthquakes, and other natural hazards, may sustain substantial damage. Although in many parts of ... -
Yield Penetration Hinge Rotation in Reinforced Concrete Beams
(American Society of Civil Engineers, 2009)Structural engineers have long recognized the importance of member ductility, that is member rotation, in the design of reinforced concrete structures in order to redistribute moment and absorb energy due to dynamic, ... -
Nonlinear Modeling of Flat-Plate Systems
(American Society of Civil Engineers, 2009)Analytical and experimental studies were undertaken to assess and improve modeling techniques for capturing the nonlinear behavior of flat-plate systems using results from shake table tests of two, approximately one-third ... -
Torsional Behavior of Concrete-Filled Circular Steel Tube Columns
(American Society of Civil Engineers, 2009)Concrete-filled tubes (CFTs) are columns commonly used in high-rise building construction due to their structural effectiveness. Past studies on CFT have focused primarily on uniaxial compression, bending, and eccentric ... -
Strut-and-Tie Nonlinear Cyclic Analysis of Concrete Frames
(American Society of Civil Engineers, 2009)A computer-based strut-and-tie model formulation procedure is presented, allowing the nonlinear cyclic response of an entire reinforced concrete structural system to be investigated. Load-carrying capacity and the failure ... -
Comparison of Field and Wind Tunnel Pressure Coefficients for a Light-Frame Industrial Building
(American Society of Civil Engineers, 2009)This technical note describes how full-scale observations of external pressure coefficients for a single storey industrial building located in Quebec City, Canada compared with matched scale at 1:200 wind tunnel measurements. ... -
Prediction of Fatigue Life of Welded Beam-to-Column Connections under Earthquake Loading
(American Society of Civil Engineers, 2009)A building may suffer damage during an earthquake as a result of inelastic deformations developed in the members or connections. It is important that the structural integrity of the building be assessed to ensure the safety ... -
Modeling of Out-of-Plane Behavior of Masonry Walls
(American Society of Civil Engineers, 2009)The flexural behavior of rectangular masonry sections is investigated by considering nonlinear stress-strain in compression and limited-tension material. A preliminary analysis shows that, with variation in the parameters ...