Journal of Structural Engineering: Recent submissions
Now showing items 3441-3460 of 10765
-
Post‐Buckling Behavior of Guyed Towers
(American Society of Civil Engineers, 1983)The post‐buckling behavior of a simple column guyed in a plane by symmetric guy wires is considered. The column is built‐in at the ground, and the structure is loaded by a single vertical force -
Editor's Note
(American Society of Civil Engineers, 2000) -
Closure to “<i>Potential Errors in Approximate Methods of Structural Analysis</i>” by R. A. Behr, C. H. Goodspeed, and R. M. Henry (April, 1989, Vol. 115, No. 4)
(American Society of Civil Engineers, 1991) -
Damage of Colliding Concrete Cubes
(American Society of Civil Engineers, 1984)Recent failures of breakwaters have been attributed to low impact strength of armor blocks. The simultaneous loss of individual weight and interlocking ability that follows failure of slender units rekindled the interest ... -
Assessment of Translational-Torsional Coupling in Asymmetric Uniform Wall-Frame Structures
(American Society of Civil Engineers, 1995)A method to predict the degree of translational-torsional coupling of mixed-bent-type multistory building structures subject to dynamic loading is presented. The method is based on the treatment of nonproportionate structures ... -
Seismic Design Parameters for Special Masonry Structural Walls Detailed with Confined Boundary Elements
(American Society of Civil Engineers, 2014)In this paper, the results from a test program focusing on the behavior of eleven fully grouted reinforced masonry (RM) structural walls containing confined boundary elements are analyzed and presented according to force, ... -
Closure to “<i>Anton Tedesko: Thin Shells and Esthetics</i>” by David P. Billington (November, 1982)
(American Society of Civil Engineers, 1984) -
Errata
(American Society of Civil Engineers, 1996) -
Editor's Note
(American Society of Civil Engineers, 1997) -
Errata
(American Society of Civil Engineers, 2000) -
Design of Cold‐Formed Stainless Steel Tubular Members. II: Beams
(American Society of Civil Engineers, 1993)The paper presents tests on square and circular stainless steel tubular beams. An important part of the test program was to quantify the increase in bending strength resulting from cold‐work during the fabrication process. ... -
Discussion of “<i>Post‐Buckling Behavior</i>” by Alexander Chajes (October, 1983)
(American Society of Civil Engineers, 1985) -
Closure to “<i>Simple Analogous Frames for Shear Wall Analysis</i>” by B. Stafford Smith and Amal Girgis (November, 1984, Vol. 110, No. 11)
(American Society of Civil Engineers, 1987) -
All Good Things
(American Society of Civil Engineers, 2000) -
Editor’s Note
(American Society of Civil Engineers, 2007) -
Review of 'Dynamic Structural Design: Inverse Problem Approach' by Izuru Takewaki
(American Society of Civil Engineers, 2001) -
Modified Interval and Subinterval Perturbation Methods for the Static Response Analysis of Structures with Interval Parameters
(American Society of Civil Engineers, 2014)To overcome the drawbacks in the traditional interval perturbation method due to the unpredictable effect of neglecting the higher-order terms of Neumann series, a modified interval perturbation method is presented and ... -
Closure to “<i>Shear Lag in Box Girders</i>” by Bogdan O. Kuzmanović and H. James Graham (September, 1981)
(American Society of Civil Engineers, 1983) -
Erratum: “Reinforced Concrete Joints Under Cyclic Loading” by Muhammad A. Mukaddam and Najib A. Kasti (April, 1986, Vol. 112, No. 4)
(American Society of Civil Engineers, 1986) -
Discussion of “<i>Wind Induced Lateral‐Torsional Motion of Buildings</i>” by Andrew Tallin and Bruce Ellingwood (Oct., 1985)
(American Society of Civil Engineers, 1987)