Journal of Structural Engineering: Recent submissions
Now showing items 3381-3400 of 10765
-
Interstory Drifts from Shear Strains at Base of High-Rise Concrete Shear Walls
(American Society of Civil Engineers, 2015)Shear strains may have negligible influence on maximum displacements at the top of slender shear walls, but may significantly increase interstory drift ratios at lower levels where gravity-load columns are often less ... -
Approximate Formulas for Effective Length of Steel Columns
(American Society of Civil Engineers, 1994)Approximate formulas are presented for use in determining the effective length of steel columns designed to American standards as an alternative to the standard nomogram technique. Their use allows the development of simple ... -
Closure to “<i>Prestress Level in Stress‐Laminated Timber Bridges</i>” by Edward F. Sarisley Jr. and Michael L. Accorsi (November 1990, Vol. 116, No. 11)
(American Society of Civil Engineers, 1992) -
Reliability-Based Analysis and Design of Wide-Span Structures under Stochastic Wind Loads
(American Society of Civil Engineers, 2014)The objective of this paper is to present a reliability-based method for structural analysis and design under stochastic wind loads so that nominal wind pressure coefficients -
Editor’s Note
(American Society of Civil Engineers, 2006) -
Editor’s Note
(American Society of Civil Engineers, 2009) -
Discussion of “<i>Semibifurcation and Bifurcation Analysis of Flexibly Connected Steel Frames</i>” by W. M. G. Ho and S. L. Chan (August, 1991, Vol. 17, No. 8)
(American Society of Civil Engineers, 1993) -
Discussion of “Punching Shear Behavior of Externally Prestressed Concrete Slabs” by H. Mostafaei, F. J. Vecchio, P. Gauvreau, and M. Semelawy
(American Society of Civil Engineers, 2012) -
Editor's Note
(American Society of Civil Engineers, 2002) -
Seismic Performance of Joist‐Pocket Connections. II: Application
(American Society of Civil Engineers, 1993)It has been known for some time that connections in unreinforced masonry structures play a major role in the performance of such structures. Few attempts have been made to analytically address these components. An understanding ... -
Lateral-Buckling Tests of Cold-Formed RHS Beams
(American Society of Civil Engineers, 1995)In this paper, tests on the lateral buckling of cold-formed rectangular hollow sections (RHS) beams under uniform bending moment are described. The section size chosen for testing is 75 × 25 × 2.5 mm, which is the largest ... -
Editor's Note
(American Society of Civil Engineers, 1998) -
Innovative Timber-Concrete Composite Structures with Prefabricated FRC Slabs
(American Society of Civil Engineers, 2015)This paper concerns the development of innovative composite floor systems, comprising timber beams and prefabricated concrete slabs. For the development of this new system, two properties were regarded as vital, as follows: ... -
Bond Anchorage of Pretensioned FRP Tendon at Force Release
(American Society of Civil Engineers, 1992)The anchorage of fiber‐reinforced plastic (FRP) tendons in pretensioned prestressed concrete (PC) members may cause the formation of cracks as a result of tendon wedge effect and mechanical interlocking during prestress ... -
Editor's Note
(American Society of Civil Engineers, 2000) -
Editorial
(American Society of Civil Engineers, 1991) -
ERRATA
(American Society of Civil Engineers, 1995) -
Damage Probability of Turbine Missile Impact
(American Society of Civil Engineers, 1984)AS part of probabilistic safety analysis, the risk of structural damage to critical components of a nuclear power power plant from accidentally generated turbine missiles has been evaluated. Perforation and scabbing modes ... -
Viscoplastic Response of Clamped Beams under Impact Loading
(American Society of Civil Engineers, 1991)A three‐stage analytical model for predicting the final midpoint deflections of viscoplastic, clamped beams under impact loading conditions is presented. The model includes traveling plastic hinges and accounts for strain ... -
Discussion of “<i>Shear Lag in Box Girders</i>” by Bogdan O. Kuzmanović and H. James Graham (September, 1981)
(American Society of Civil Engineers, 1983)