Journal of Structural Engineering: Recent submissions
Now showing items 3121-3140 of 10765
-
Aerodynamic Damping and Seismic Response of Horizontal Axis Wind Turbine Towers
(American Society of Civil Engineers, 2014)Aerodynamic damping has an important effect on the seismic response of horizontal axis wind turbines (HAWTs). Some researchers have estimated that aerodynamic damping in operational HAWTs is -
Design, Testing, and Detailed Component Modeling of a High-Capacity Self-Centering Energy-Dissipative Brace
(American Society of Civil Engineers, 2015)The self-centering energy-dissipative (SCED) brace is an innovative cross brace for buildings that provides a nonlinear response with good energy dissipation and postyield stiffness while minimizing residual drift after ... -
Local–Global Interaction Buckling of Stainless Steel I-Beams. I: Experimental Investigation
(American Society of Civil Engineers, 2015)This paper describes an experimental program investigating the local–global interaction buckling of stainless steel I-section beams. Three alloys were included: austenitic S30401, ferritic S44330, and lean duplex S32101. ... -
System that Learns to Design Cable-Stayed Bridges
(American Society of Civil Engineers, 1995)The critical design decisions in bridge design are made at the preliminary design stage. They depend on the expertise of the designer, built up from extensive experience. Experience is difficult to acquire, and may be ... -
Closure to “<i>Columns with Semirigid Joints</i>” by Stephen W. Jones, Patrick A. Kirby, and David A. Nethercot (February, 1982)
(American Society of Civil Engineers, 1983) -
Closure to “<i>Gustave Eiffel: A Biographical Sketch</i>” by John S. Ellis (June, 1986, Vol. 112, No. 6)
(American Society of Civil Engineers, 1987) -
Discussion of “<i>Modeling of R/C Joints Under Cyclic Excitations</i>” by Filip C. Filippou, Egor P. Popov, and Vitelmo V. Bertero (November, 1983)
(American Society of Civil Engineers, 1984) -
Discussion of “<i>Design Formulas for Unstiffened and Stiffened Plate Girders in Shear</i>” by Max A. M. Herzog (November, 1989, Vol. 115, No. 11)
(American Society of Civil Engineers, 1991) -
Discussion of “<i>Structural Serviceability: Floor Vibrations</i>” by Bruce Ellingwood and Andrew Tallin (February, 1984)
(American Society of Civil Engineers, 1985) -
Discussion of “<i>Gustave Eiffel: A Biographical Sketch</i>” by John S. Ellis (June, 1986, Vol. 112, No. 6)
(American Society of Civil Engineers, 1987) -
Editor's Note
(American Society of Civil Engineers, 2003) -
Editor's Note
(American Society of Civil Engineers, 1999) -
Closure to “<i>Load Interaction in T‐Joints of Steel Circular Hollow Sections</i>”by Alex Stamenkovic and Keith D. Sparrow(September, 1983)
(American Society of Civil Engineers, 1984) -
Dynamic Behavior of Slant‐Legged Rigid‐Frame Highway Bridge
(American Society of Civil Engineers, 1994)The slant‐legged rigid‐frame bridge is one type of the most widely used highway bridges. However, very few dynamic characteristics of this type of bridges have been reported. The objective of this paper is to investigate ... -
Long-Term Behavior of Posttensioned Timber Connections
(American Society of Civil Engineers, 2015)Tests regarding the long-term behavior of posttensioned timber connections have been performed at the ETH in Zurich. The aim of these tests is to estimate the loss in tendon force that can be expected during the lifetime ... -
Influence of Vertical Ground Shaking on Horizontal Response of Seismically Isolated Buildings with Friction Bearings
(American Society of Civil Engineers, 2016)This paper focuses on a horizontal-vertical coupling effect observed in a full-scale shake table experiment of a 5-story moment frame building isolated with triple pendulum bearings. A significant increase or amplification ... -
Simplified Approaches to Design Medium-Rise Unbraced Steel Storage Pallet Racks. II: Fundamental Period Estimates
(American Society of Civil Engineers, 2015)This paper concludes a two-part paper, which addresses the reliability of simplified approaches for rack design. The first part presents a parametric study on medium-rise, unbraced racks differing for components, geometry, ... -
Time-Variant Flexural Reliability of Posttensioned, Segmental Concrete Bridges Exposed to Corrosive Environments
(American Society of Civil Engineers, 2014)Posttensioned (PT) bridges are used on major thoroughfares because they are economical structures for traversing long spans. Special inspections of these bridges have revealed corrosion of the strands at void locations in ... -
Strongback System: A Way to Reduce Damage Concentration in Steel-Braced Frames
(American Society of Civil Engineers, 2015)This paper examines a newly developed seismic force-resisting system: the strongback system (SBS). To achieve improved seismic performance, this system combines aspects of a traditional concentric braced frame with a mast ... -
Dynamic Characterization of Prestressed Rods in Stressed Timber Systems
(American Society of Civil Engineers, 1993)Analytical and experimental approaches are presented to monitor the tension levels in posttensioned high‐strength steel rods of stressed‐timber systems. The dynamic response of these rods under an impact load is correlated ...