Journal of Engineering Mechanics: Recent submissions
Now showing items 2561-2580 of 7001
-
Closure to “Numerical Analysis of Geomaterials within Theory of Porous Media” by Pedro Arduino and Emir Jose Macari
(American Society of Civil Engineers, 2002) -
Non-Gaussian Model for Ringing Phenomena in Offshore Structures
(American Society of Civil Engineers, 2002)Significant interest has been shown in identifying the nonlinear mechanisms that induce a ringing type response in offshore structural systems. This high frequency transient type response has been observed in offshore ... -
Tuned Mass Damper Design for Optimally Minimizing Fatigue Damage
(American Society of Civil Engineers, 2002)Traditionally the usage of a tuned mass damper (TMD) is to improve the survivability of the primary structure under an extraordinary loading environment while the design loading condition is often described by a harmonic ... -
Homogenized Strategy toward Constitutive Identification of Masonry
(American Society of Civil Engineers, 2002)The aim of this work is the study of masonry behavior by means of a homogenized model in several perturbative parameters. The difficulty in the mechanical modeling of masonry depends on its -
In-Plane Elastic Stability of Arches under a Central Concentrated Load
(American Society of Civil Engineers, 2002)This paper is concerned with the in-plane elastic stability of arches with a symmetric cross section and subjected to a central concentrated load. The classical methods of predicting elastic buckling loads consider bifurcation ... -
Anisotropic Elastoplastic Bounding Surface Model for Cohesive Soils
(American Society of Civil Engineers, 2002)The initial stresses existing in the natural ground are anisotropic in the sense that the vertical stress is typically larger than the lateral stresses. The construction activities, such as embankments and excavation, ... -
Discussion of “Numerical Analysis of Geomaterials within Theory of Porous Media” by Pedro Arduino and Emir Jose Macari
(American Society of Civil Engineers, 2002) -
Effective Toughness of Damaged Solids Containing Ribbon Cracks
(American Society of Civil Engineers, 2002)The crack-tip toughness of materials with two-dimensional random orientation of ribbon cracks is evaluated theoretically. The effective elastic moduli reduce when the cracks exist within the isotropic material so as to ... -
Influence of Permeability on Liquefaction-Induced Shear Deformation
(American Society of Civil Engineers, 2002)Permeability of a liquefiable soil profile may affect the rate of pore-pressure buildup and subsequent dissipation during and after earthquake excitation. Consequently, effective soil confinement and available resistance ... -
Experiments to Relate Acoustic Emission Energy to Fracture Energy of Concrete
(American Society of Civil Engineers, 2002)Acoustic emission (AE) was used to measure energy associated with fracture of standard concrete test specimens. The goal of the work was to identify ways in which AE could be used to quantify damage in generic laboratory ... -
Tripartite Cohesive Crack Model
(American Society of Civil Engineers, 2002)A new multicomponent cohesive crack model for concrete is presented. The model, which is directly applicable to interface finite elements, has three main components termed undamaged, bridging, and fully debonded. The ... -
Creep and Shrinkage Effect on Reinforced Concrete Slab-and-Beam Structures
(American Society of Civil Engineers, 2002)In this paper a solution to the bending problem of reinforced concrete slab-and-beam structures including creep and shrinkage effect is presented. The adopted model takes into account the resulting in-plane forces and ... -
Three-Dimensional Model for Analysis of Stiffness and Hygroexpansion Properties of Fiber Composite Materials
(American Society of Civil Engineers, 2002)A three-dimensional model for stiffness and hygroexpansion of fiber and particle composite materials is presented. The model is divided into two steps, first a homogenization of a single fiber with a coating representing ... -
Semi-Implicit Integration Algorithm for Stochastic Analysis of Multi-Degree-of-Freedom Structures
(American Society of Civil Engineers, 2002)This paper presents a semi-implicit integration algorithm for random vibration problems that is appropriate for analyzing large structures, nonlinear hysteretic systems, and structural control problems. This semi-implicit ... -
Generalized-α Time Integration Solutions for Hanging Chain Dynamics
(American Society of Civil Engineers, 2002)In this paper, we study numerically the two- and three-dimensional nonlinear dynamic response of a chain hanging under its own weight. Previous authors have employed the box method, a finite-difference scheme popular in ... -
Nonclassical Modes of Unrestrained Shear Beams
(American Society of Civil Engineers, 2002)This paper considers the effect that a rotational motion has on the normal modes of a shear beam that is free to rotate, either because it is free in space or it is pivoted at one end. It is shown that the classical solutions ... -
Classic Buckling of Three-Dimensional Multicolumn Systems under Gravity Loads
(American Society of Civil Engineers, 2002)The elastic stability of three-dimensional (3D) multicolumn systems under gravity loads is analyzed in a condensed manner using the classical Timoshenko stability functions. The characteristic equations corresponding to ... -
Fatigue Fracture of Concrete Subjected to Biaxial Stresses in the Tensile C-T Region
(American Society of Civil Engineers, 2002)In this paper cyclic quasi-static and constant amplitude fatigue responses of concrete subjected tensile compression–tension -
Solution Method for Beams on Nonuniform Elastic Foundations
(American Society of Civil Engineers, 2002)This technical note presents an analytical method, accompanied by a numerical scheme, to evaluate the response of beams on nonuniform elastic foundations, namely, when the foundation modulus is -
Material Identification Procedure for Elastoplastic Drucker–Prager Model
(American Society of Civil Engineers, 2002)A procedure to identify the material parameters of an elastoplastic model is presented. It aims to predict uniaxial stress–strain curves in tension or compression. The Drucker–Prager model is chosen because of its simplicity. ...