Journal of Engineering Mechanics: Recent submissions
Now showing items 1801-1820 of 7001
-
Comparison between Hydraulic and Thermal Spalling in Heated Concrete Based on Numerical Modeling
(American Society of Civil Engineers, 2007)Two spalling mechanisms are generally quoted in literature. The first one is due to pore pressure buildup (tensile stresses). The second one is generated by restrained thermal dilation (compressive stresses). This paper ... -
Simulation of Nonstationary Stochastic Processes by Spectral Representation
(American Society of Civil Engineers, 2007)This paper presents a rigorous derivation of a previously known formula for simulation of one-dimensional, univariate, nonstationary stochastic processes integrating Priestly’s evolutionary spectral representation theory. ... -
Time-Dependent Response of an Axially Loaded Elastic Bar in a Multilayered Poroelastic Medium
(American Society of Civil Engineers, 2007)This paper considers load transfer from an axially loaded long elastic bar into a multilayered poroelastic half-space. The problem is analyzed by decomposing the bar-half-space system into an extended half-space governed ... -
Flexible Videogrammetric Technique for Three-Dimensional Structural Vibration Measurement
(American Society of Civil Engineers, 2007)A videogrammetric technique is proposed for measuring three-dimensional structural vibration response in the laboratory. The technique is based on the principles of close-range digital photogrammetry and computer vision. ... -
Imaging Concrete Structures Using Air-Coupled Impact-Echo
(American Society of Civil Engineers, 2007)In this paper, air-coupled impact-echo is successfully applied for nondestructive evaluation of concrete. The air-coupled sensor is a small ( -
Vibration of Annular Mindlin Plates with Small Cores
(American Society of Civil Engineers, 2007)In most publications on vibration of annular plates, the natural frequencies are only presented for inner radius as small as one-tenth of its outer radius, but there are hardly any results presented for cores smaller than ... -
Early-Time Solution for a Radial Hydraulic Fracture
(American Society of Civil Engineers, 2007)The small-time asymptotic solution for a penny-shaped fluid-driven fracture is obtained semianalytically. Scaling considerations indicate that the portion of the fracture that is filled with fluid increases with time ... -
Techniques for Numerical Simulations of Concrete Slabs for Demolishing by Blasting
(American Society of Civil Engineers, 2007)The subject of this article is the numerical simulation of concrete under explosive loading using a meshbased and a meshfree discretization technique. The presented techniques are verified by experimental data. Experimental ... -
Approach for Overcoming Numerical Inaccuracy Caused by Load Discontinuity
(American Society of Civil Engineers, 2007)It was found that the discontinuity at the end of an impulse will lead to numerical inaccuracy as this discontinuity will result in an extra impulse and thus an extra displacement in the time history analysis. In addition, ... -
Nonlinear Dynamical Model for Hysteresis Based on Nonconvex Potential Energy
(American Society of Civil Engineers, 2007)A model for hysteretic dynamics is proposed in the current paper. Hysteresis is treated as an input–output relation for a dynamic system. The Lagrangian of the dynamic system is constructed on the basis of a nonconvex ... -
Dynamic Fracture Simulation of Concrete Using a Virtual Internal Bond Model
(American Society of Civil Engineers, 2007)A multiscale virtual internal bond (VIB) model for isotropic materials has been recently proposed to describe material deformation and fracture under quasi-static and dynamic loading situations. Fracture simulation using ... -
Enhanced, Unconditionally Stable, Explicit Pseudodynamic Algorithm
(American Society of Civil Engineers, 2007)In performing a pseudodynamic test, an explicit method is generally preferred over an implicit method since it involves no iteration procedure or extra hardware that is often needed for an implicit method. However, its ... -
Errata for “Thermomechanical Postbuckling Analysis of Cross-Ply Laminated Cylindrical Shell Panels” by J. Girish and L. S. Ramachandra
(American Society of Civil Engineers, 2007) -
Viscous Heating of Fluid Dampers under Small and Large Amplitude Motions: Experimental Studies and Parametric Modeling
(American Society of Civil Engineers, 2007)This paper summarizes the results from a comprehensive experimental program in an effort to better understand the phenomenon of viscous heating of fluid dampers under small-stroke (wind loading) and large-stroke (earthquake ... -
Generalized Masing Approach to Modeling Hysteretic Deteriorating Behavior
(American Society of Civil Engineers, 2007)The modeling of hysteretic behavior is of significant importance in several areas, including civil engineering and mechanics. This paper focuses on finding a method for modeling hysteretic behavior that is simple and ... -
Computational Analysis of Masonry Structures with a Funicular Model
(American Society of Civil Engineers, 2007)This paper presents a computational approach for the assessment of masonry structures based on the well known analogy between the equilibrium of arches and that of hanging strings or cables working in tension. According ... -
Stochastic Dynamic Analysis of Inelastic Structures Using Force Analogy Method
(American Society of Civil Engineers, 2007)The force analogy method which has been proven to be very efficient in dynamic analysis of inelastic structures is here introduced for the first time into the field of stochastic dynamic analysis for inelastic structures. ... -
Flotation to Trigger Lateral Buckles in Pipelines on a Flat Seabed
(American Society of Civil Engineers, 2007)Triggering lateral buckles in subsea pipelines can be an effective way to ensure that the thermal expansion is spread over several buckles at a controlled spacing, rather than concentrating in a single buckle that may ... -
Approximate Reliability-Based Optimization Using a Three-Step Approach Based on Subset Simulation
(American Society of Civil Engineers, 2007)A novel three-step approach is proposed to solve reliability-based optimization (RBO) problems. The new approach is based on a novel approach previously developed by the authors for estimating failure probability functions. ... -
Linear Predictor-Based Lossless Compression of Vibration Sensor Data: Systems Approach
(American Society of Civil Engineers, 2007)This paper presents a novel systems approach to compressing sensor network data. Unlike previous data compression methods, the proposed lossless linear predictor-based sensor data compression method utilizes structural ...